Scribd Logo
Upload

Welcome to Scribd!

  • 17 views

    Novo PRO Alkyd Glossy

    Uploaded by

    wael barbary

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Novo PRO Alkyd Glossy

    Uploaded by

    wael barbary
    17 views1 page

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    17 views1 page

    Novo PRO Alkyd Glossy

    Uploaded by

    wael barbary

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Novo PRO alkyd Glossy

    Last update: - 1 / 09 / 2021 (1)

    High gloss Synthetic enamel paint.


    DEFINITION SURFACE PREPARATION
    Novo PRO is high glossy synthetic enamel • The surface of the substrate should be
    paint, based on Alkyd resin and other selected cleaned from oil, grease, dirt, and loose
    pigments and fillers. particles.
    • The surface should be smoothed well by
    ADVANTAGES suitable putty and blasted to be smooth.
    1. Acquire a homogenous consistency by • The substrate should be primed or coated
    manual mixing. with suitable under coat (Novo GO ) then
    2. Easy to apply. left to dry and smoothed down with sand
    paper.
    3. High coverage because of finely grounded
    • Steel surface should be plastered and primed
    using and high-quality pigments.
    by Novo Prime R.
    4. After drying, it produces glossy elastic
    • Mix well the contents that will be used.
    homogenous film that is well adhered to
    • One or two coats of Novo PRO are
    the substrate and resisted abrasion and
    recommended to apply.
    scratching. • Can be applied by brush, roller or spraying
    USES gun.
    ▪ Can be applied on synthetic primer,
    • Can be thinned by Novo sol M 8 if needed.
    undercoat or on both also. • Clean tools after finishing by Novo sol T 9
    ▪ On wood, metal and plastered surface. or Novo sol M 8

    PHYSICAL PROPERTIES @ 25 Cº COVERAGE


    • 12-15 m2 / L /30-micron DFTcoat.
    DISCRIPTION VALUE
    (depending on the surface condition and
    Color white and colored type)
    Density (1.10 ±0.05) gm. / cm 3 STORAGE CONDITIONS
    Viscosity 25 ± 5 poise • Best stored at room temperature in dry
    conditions.
    Solid content (by WT.) (60 ±2) % • Avoid humidity, cold freezing
    Solid content (by Vol.) (40 ±2) % conditions and off concrete floors.
    Surface dry 6 hrs. • Do not store in direct sunlight. (10 -30) Cº
    PRECAUTIONS & SAFETY
    Hard dry 24 hrs.
    o Wear protective clothes, gloves, glasses
    Full cure 7 days and face protection.
    Thinner Sol M 8 o Application should be carried out in
    Shelf life 12 months ( in suitable well ventilate place.
    storage conditions) o For skin contact, remove it with suitable
    cream followed by soap and water cleaning.
    o Don’t eat or smoke during use.

    ISSUE DATE/REV: - 1/5/2021 ISSUE REV NO: - 2/1 FP-14-07/EN

    You might also like