Royco 756 Mil PRF 5606h Sds
Royco 756 Mil PRF 5606h Sds
Royco 756 Mil PRF 5606h Sds
Company: Manufacturer
Anderol Specialty Lubricants, a division of Lanxess Solutions US Inc.
215 Merry Lane
East Hanover, NJ
07936
United States of America (USA)
Form liquid
Colour red
Odour aromatic
GHS Classification
Aspiration hazard : Category 1
Acute aquatic toxicity : Category 3
Chronic aquatic toxicity : Category 3
Hazard pictograms :
Carcinogenicity:
IARC No component of this product present at levels greater than or
equal to 0.1% is identified as probable, possible or confirmed
human carcinogen by IARC.
Hazardous components
If inhaled : If inhaled
Move to fresh air.
If not breathing, give artificial respiration.
If breathing is difficult, give oxygen.
In case of bluish discolouration (lips, ear lobes, fingernails),
give oxygen as quickly as possible.
Call a physician or poison control centre immediately.
Most important symptoms : Aspiration may cause pulmonary oedema and pneumonitis.
and effects, both acute and
delayed
Notes to physician : For specialist advice physicians should contact the Poisons
Information Service.
Foam
Alcohol-resistant foam
Water mist
Special protective equipment : In the event of fire, wear self-contained breathing apparatus.
for firefighters Use personal protective equipment.
Methods and materials for : Contain spillage, soak up with non-combustible absorbent
containment and cleaning up material, (e.g. sand, earth, diatomaceous earth, vermiculite)
and transfer to a container for disposal according to local /
national regulations (see section 13).
Conditions for safe storage : Keep container tightly closed in a dry and well-ventilated
place.
(Inhalable
fraction and
vapor)
TWA 10 mg/m3 NIOSH REL
PEL 10 mg/m3 CAL PEL
Engineering measures : Ensure that eyewash stations and safety showers are close to
the workstation location.
Effective exhaust ventilation system
Hand protection
Remarks : Neoprene gloves
Appearance : liquid
Color : red
Odor : aromatic
Odour Threshold : No data available
pH : Not applicable
pour point : < -60 °C
Viscosity
Viscosity, kinematic : 13.9 mm2/s (40 °C)
Acute toxicity
Components:
2,6-di-tert-butyl-p-cresol:
Acute oral toxicity : LD50 (Rat, male and female): > 2,930 mg/kg
Method: OECD Test Guideline 401
GLP: yes
Acute dermal toxicity : LD50 (Rat, male and female): > 2,000 mg/kg
Method: OECD Test Guideline 402
GLP: yes
Skin corrosion/irritation
Components:
NJTS# 136411-5778P Polyolefins:
Result: No skin irritation
2,6-di-tert-butyl-p-cresol:
Species: Rabbit
Result: No skin irritation
Components:
NJTS# 136411-5778P Polyolefins:
Result: No eye irritation
2,6-di-tert-butyl-p-cresol:
Species: Rabbit
Result: No eye irritation
Components:
2,6-di-tert-butyl-p-cresol:
Species: Guinea pig
Assessment: Did not cause sensitisation on laboratory animals.
Components:
NJTS# 136411-5778P Polyolefins:
Genotoxicity in vitro : Test Type: Ames test
Metabolic activation: with and without metabolic activation
Result: negative
Germ cell mutagenicity - : Animal testing did not show any mutagenic effects.
Assessment
SAP 6.0 SDS 2012-2 NA GHS 8 / 14 SDS Number: 400000001788
SAFETY DATA SHEET
2,6-di-tert-butyl-p-cresol:
Genotoxicity in vitro : Test Type: Ames test
Metabolic activation: with and without metabolic activation
Result: negative
Germ cell mutagenicity - : Animal testing did not show any mutagenic effects.
Assessment
Carcinogenicity
Components:
NJTS# 136411-5778P Polyolefins:
Carcinogenicity - : Animal testing did not show any carcinogenic effects.
Assessment
2,6-di-tert-butyl-p-cresol 128-37-0
Reproductive toxicity
Components:
NJTS# 136411-5778P Polyolefins:
Reproductive toxicity - : No toxicity to reproduction
Assessment No effects on or via lactation, Did not show teratogenic effects
in animal experiments.
2,6-di-tert-butyl-p-cresol:
Reproductive toxicity - : No toxicity to reproduction
Assessment No effects on or via lactation
Components:
NJTS# 136411-5778P Polyolefins:
Exposure routes: Oral
Assessment: The substance or mixture is not classified as specific target organ toxicant,
repeated exposure.
2,6-di-tert-butyl-p-cresol:
Exposure routes: Oral
Assessment: The substance or mixture is not classified as specific target organ toxicant,
repeated exposure.
Aspiration toxicity
Components:
Distillates (petroleum), hydrotreated light naphthenic:
May be fatal if swallowed and enters airways.
Further information
Product:
SAP 6.0 SDS 2012-2 NA GHS 10 / 14 SDS Number: 400000001788
SAFETY DATA SHEET
Ecotoxicity effects
Ecotoxicology Assessment
Results of PBT assessment (Product)
This mixture contains no substance considered to be persistent, bioaccumulating and toxic (PBT).
Additional ecological : The product itself has not been tested.
SAP 6.0 SDS 2012-2 NA GHS 11 / 14 SDS Number: 400000001788
SAFETY DATA SHEET
information (Product)
Disposal methods
Waste from residues : Dispose of waste material in compliance with all federal, state,
and local regulations.
Contaminated packaging : Do not burn, or use a cutting torch on, the empty drum.
International Regulations
UNRTDG
Not regulated as a dangerous good
IATA-DGR
Not regulated as a dangerous good
IMDG-Code
Not regulated as a dangerous good
Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code
Not applicable for product as supplied.
National Regulations
49 CFR
Not regulated as a dangerous good
SARA 313 : This material does not contain any chemical components with
known CAS numbers that exceed the threshold (De Minimis)
reporting levels established by SARA Title III, Section 313.
US State Regulations
California Prop 65 WARNING! This product contains a chemical known to the
State of California to cause cancer.
formaldehyde 50-00-0
Please note that Section 3 of this document lists only the hazardous components required
by the specific country or region hazard communication regulations. The chemical
identifiers listed in Section 3 are used globally for hazard communication purposes and
may not reflect those used for chemical inventory coverage in a particular country or
region. The chemical inventory information given in Section 15 of this document applies
to the product as a whole and should be used when evaluating inventory compliance.
Further information
The information provided in this Safety Data Sheet is correct to the best of our knowledge,
information and belief at the date of its publication. The information given is designed only as
SAP 6.0 SDS 2012-2 NA GHS 13 / 14 SDS Number: 400000001788
SAFETY DATA SHEET
a guidance for safe handling, use, processing, storage, transportation, disposal and release
and is not to be considered a warranty or quality specification. The information relates only to
the specific material designated and may not be valid for such material used in combination
with any other materials or in any process, unless specified in the text.