CNC Programing & Machining
CNC Programing & Machining
122. The button that will reactive the CNC program after temporary stoppage is ….
A) Cycle start
B) Reset
C) Feed hold
D) Emergency Stop
124. The ……mode is helpful when you are trying out a new program.
A) AUTO B) ZRN
C) JOG D) EDIT
126. Which is the correct expression for the unit of feed rate in milling?
A) m/min B) mm/rev
C) mm/sec D) mm/min
139. The display screen mode that lets the operator enter tooling related data is the ______.
(a) Alarm Page (b) Program page
(c) Offset page (d) Position page
144. The ___________ mode is helpful when you are run the program.
(a) Edit (b) Jog
(c) ZRN (d) Auto
149. What mode switch position allows lets you move the machine axis manually?
(a) EDIT (b) MDI
(c) JOG (d) MEM
ANSWER KEY