Hadad 0927 D 12

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

High-density Directional Antenna

Model: : HADAD-0927-D-12
Features and Product Description
• Low PIM • High reliability
• High Gain • RoHS Compliant

Electrical Specifications
Port Port 1 Port 2

Frequency range (MHz) 880-960 1710-2700 880- 960 1710-2700

Polarization +45° -45°

Gain (dBi) ≥10 ≥10

Horizontal half-power beam width (°) 60 60 60 60

Vertical half-power beam width (°) 25 20 25 20

Vertical Side lobe suppression (dB) ≥18

CPR at Boresight (dB) ≥17

Front to Back Ratio (dB) ≥24

VSWR ≤1.5

Isolation (dB) ≥23

PIM, 3rd Order (dBc) ≤ -150 (2 x 43 dBm )

Average power, maximum (W) 100

Impedance (Ω) 50

Grounding DC Ground

Mechanical Specifications
Dimensions (H x W x D) (mm) 650×370×124

Antenna installation kit/weight (kg) 6.8 / 6

Radome material Fiberglass


Indoor / Outdoor(Only for A and B
Application
scenarios)
Operating temperature (℃) -40 to +60

Rated Wind Velocity (km/h) 150

Connector 2 x 7-16 DIN-Female

Huawei Technologies Co., Ltd. Bantian, Longgang District, Shenzhen 518129, P.R.China www.huawei.com

1
Dual Polar Directional Antenna
Model: : HADAD-0927-D-12
Antenna Installation Instruction
Step 1: Please check all the components in the list
are provided and have not been damaged. The
installed brackets are shown in the figure above.

Step 2: As shown above, use M10 square neck Step 3: Use M8 square neck bolts, nuts, spring
bolts,M10 square neck bolt, nut, spring washer, flat pads, flat washers to fasten the bracket onto
washer to fasten the adjusting plates together using the antenna,According to directions of Holding
torque spanner with torque 25Nm. pole to choose hole position with torque
20Nm.

Step 4: Use U bolt and nuts to fasten the antenna Step 5-1: Loosen the M10nuts on the scale
onto the mast using torque spanner with torque indicator, and horizontally rotate the antenna
25Nm.The left is picture of longitudinal holding until the mechanical tilt angle of the antenna is
pole,The right is picture of horizontal holding pole. adjusted to a specified value. Lock all the
The mast diameter should be in the range of fasteners with torque wrench. The horizontal
70mm to 114mm. mechanical tilt range is -45°to +45°。

Step 5-2, loosen the M10 nuts on the mounting plate,


adjust the mechanical inclination of the antenna in the
vertical direction to the appropriate position through the
corner plate A, and lock all fasteners with the torsion
wrench. The adjustable range of mechanical inclination
in vertical direction is - 45 -+45.
Huawei Technologies Co., Ltd. Bantian, Longgang District, Shenzhen 518129, P.R.China www.huawei.com

You might also like