CERTIFICATE OF QUALITY SYSTEM APPROVAL

In accordance with the requirements of the Pressure Equipment (Safety)

Regulations 2016, UK Statutory Instrument 2016 No. 1105, as amended.
This is to certify that the Quality Management System of:

Jindal Stainless Limited

Hot Rolling & Cold Rolling Division
O.P Jindal Marg
Hisar 125 005, Haryana, India
has been assessed against the requirements of Schedule 2, Paragraph 31.8 of the Pressure
Equipment (Safety) Regulations 2016 and conforms to the requirements for the products
shown below:

Manufacture of Stainless-Steel Hot Rolled and Cold Rolled Coils, Plates,

Sheets & Strips and Cold Rolled Non-Ferrous Alloys Coils & Sheets
Approval is subject to the continued maintenance of the quality system in accordance with
the requirements of the above Regulation and the ongoing surveillance. Products are as
detailed on the attached schedule.

Certificate No: 0038/UK/PER/MUM/2210018/2

Original Approval: 29 July 2022
Current Certificate: 25 May 2023
Certificate Expiry: 28 July 2025
LRQA Approved Body 0038

______________________________________________
Shyam Gopalakrishnan on behalf of LRQA Verification Limited

LRQA Verification Limited (Reg. no. 4929226) is a limited company registered in England and Wales. Registered office: 1 Trinity Park, Bickenhill Lane, Birmingham B37 7ES.
A subsidiary of LRQA Group Limited.
LRQA Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'LRQA'. LRQA assumes
no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless
that person has signed a contract with the relevant LRQA entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms
and conditions set out in that contract.

PER Schedule 2 31_8 - Template - Rev 1 - November 2021 Page 1 of 2

 CERTIFICATE SCHEDULE
0038/UK/PER/MUM/2210018/2
In accordance with the requirements of the Pressure Equipment (Safety)
Regulations 2016, UK Statutory Instrument 2016 No. 1105, as amended.
Products
Material Thickness Range Heat Treatment /
Product Form
Specification Grade / Designation (Min / Max) in mm Supply Condition
X5CrNi18-10 (1.4301)
X2CrNiMo17-12-2 (1.4404)
X6CrNiTi18-10 (1.4541)
Cold Rolled Strips, ≤5
X2CrNi 18-9 (1.4307) Coils & Sheets
EN 10028-7 X5CrNiMo17-12-2 (1.4401) As Specified in
Hot Rolled Strips, 2/12
X2CrNiMo18-15-4 (1.4438) Material Specification
Coils, Sheet & Plate
X6CrNi18-10 (1.4948) Hot Rolled Plates 5/60
X2CrNiN18-7 (1.4318)
X6Cr NiMoTi17-12-2 (1.4571)
X2Cr Ni12 (1.4003)
201, 202, 301, 301L, Cold Rolled Strips, ≤5
301LN,304, 304L,304H, 316,
316L 316Ti, 317L, Coils & Sheets
ASME SA240/ Hot Rolled Strips, 2/12
321, 321H, 309S, 310S, As Specified in
ASTM A240 Coils, Sheet & Plate
409, 430, 410, 410S, 347, Material Specification
S32205, S31803, S32304, Hot Rolled Plates 5/60
S32750, S32760
Cold Rolled Strips, ≤5
Coils & Sheets
ASME SA240/ As Specified in
S41500, 420 Hot Rolled Strips, 2/12
ASTM A240 Material Specification
Coils, Sheet & Plate
Hot Rolled Plates 5/60
EN 1652- 1997 Cold Rolled Strips & 0.7 to 1.0
As Specified in
Amendment CuSn6/CW452K Coils.
Material Specification
2003
Cold Rolled Strips & ≤1 X15CrNiSi20-12
EN 10095 X15CrNiSi20-12 (1.4828)
Coils. (1.4828)

Schedule Issue: 03
Date of Schedule Issue: 25 May 2023
LRQA Approved Body: 0038

Shyam Gopalakrishnan on behalf of LRQA Verification Limited

LRQA Verification Limited (Reg. no. 4929226) is a limited company registered in England and Wales. Registered office: 1 Trinity Park, Bickenhill Lane, Birmingham B37 7ES.
A subsidiary of LRQA Group Limited.
LRQA Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'LRQA'. LRQA assumes
no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless
that person has signed a contract with the relevant LRQA entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms
and conditions set out in that contract.

PER Schedule 2 31_8 - Template - Rev 1 - November 2021 Page 2 of 2