0% found this document useful (0 votes)
20 views2 pages

Sensorforblind

Uploaded by

Stanley Romero
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
20 views2 pages

Sensorforblind

Uploaded by

Stanley Romero
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

#define trigPin 2 // TRIG pin of ultrasonic sensor

#define echoPin 3 // ECHO pin of ultrasonic sensor


#define buzzerPin A3 // pin for the buzzer
#define motorPin 4 //pin for the vibration motor

void setup() {
Serial.begin(9600);
pinMode(trigPin, OUTPUT);
pinMode(echoPin, INPUT);
pinMode(buzzerPin, OUTPUT);
pinMode(motorPin, OUTPUT);
}
void loop() {
long duration, distance;

// Clear the trig pin


digitalWrite(trigPin, LOW);
delayMicroseconds(2);

// Send 10us pulse to trigger the ultrasonic sensor


digitalWrite(trigPin, HIGH);
delayMicroseconds(10);
digitalWrite(trigPin, LOW);

// Measure the duration of the echo signal


duration = pulseIn(echoPin, HIGH);

// Calculate distance in cm
distance = duration * 0.034 / 2;

Serial.print("Distance: ");
Serial.print(distance);
Serial.println(" cm");

// If an object is detected within a range of (30cm), activate the buzzer and vibration motor
if (distance > 0 && distance < 30) {
tone(buzzerPin, 100); // atart the buzzer tone at 1000Hz
digitalWrite(motorPin, HIGH); // activate the vibration motor
} else {
noTone(buzzerPin); // stop the buzzer tone
digitalWrite(motorPin, LOW); // deactivate the vibration motor
}

delay(0); // duration time before taking another measurement, i put Zero to make it no delay
}

You might also like