Ventilo Vol. - 2
Ventilo Vol. - 2
Ventilo
A Breathable Wall
TA B L E O F C O N T E N T S
Index
*14 *Trinity
More Designs Comming Soon...
15 Crossbow
Gardenia - B
(2 Pcs. Set)
Ver cal garden mania
16 *Neo Flora - 2.5 pcs. combo 2 pc. combo block
Page No. 09
Ventilo
A Breathable Wall
216 mm 60 mm
Rohmboz
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.20 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
01 Ventilo
A Breathable Wall
216 mm 60 mm
Q Box
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.45 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
02 Ventilo
A Breathable Wall
216 mm 60 mm
Petal
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.75 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
03 Ventilo
A Breathable Wall
216 mm 60 mm
Flora
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.45 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
04 Ventilo
A Breathable Wall
216 mm 60 mm
Trinity
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 2.85 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
05 Ventilo
A Breathable Wall
216 mm 60 mm
Crossbow
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.5 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
06 Ventilo
A Breathable Wall
216 mm 60 mm
Neo Flora
216 mm
Size : 216 x 216 x 60 (mm)
3.4 Kgs Approx
Weight : 3.5
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
07 Ventilo
A Breathable Wall
Neo Flora Neo Petal - Front Neo Petal - Back
216 mm 60 mm
Hollow Cube
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.5 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
08 Ventilo
A Breathable Wall
Hollow Cube Hollow Sphere
216 mm 60 mm
Gardenia
216 mm
Size : 216 x 216 x 60 (mm)
Weight : 3.5 Kgs Approx
Requirement Per Sq.Ft. : 2 Pcs.
Pieces Per Box : 6 Pcs.
Sq. Fts. Per Box : 3 Sq. Fts.
09 Ventilo
A Breathable Wall
Gardenia - A Gardenia - B
INSTALLATION GUIDE
PRIOR TO INSTALLATION OF THE MATERIAL PLEASE GO THROUGH THIS GUIDE CAREFULLY
• Do not install the ventilo blocks on the smooth and • Watering the blocks before installation is important.
fragile bases such as flimsy surfaces or dust covered,
ceramic, mosaic, tiles etc.
• Do not install the product if it is not in compliance with • Watering the finished wall after installation for 5
the specifications. Contact your supplier as soon as consecutive days (4 times a day).
possible, producing the relevant purchasing invoice.
• During installation in extreme climates, we suggest to • These steps are very important which effects directly to
use adhesives as per the specifications. the wall quality later.
INSTALLATION PROCEDURE
Measure the height and width of the Clean the blocks using a dry plastic Place the block by pressing hard to
estimated wall. brush. ensure a very good adherence
of the mortar on the side surface
Wall should be reinforced vertically While preparing mortar, consider
of the block.
and horizontally with iron rebar the right amount of water, for good
between the gap of two blocks, accretion and the right consistency Use a rubber mallet(rubber hammer)
If the wall is over 2.5 meter height, of mortar. to properly fix and level the block,
and over 4 meter width, it should in order not to wound the block.
For adding space between the joint
be locked by the 3-5 cm concrete
use spacer of desirable width, usually Use the normal tile cutting machine,
beam.
between 5-10 mm. if needed.
First clean the surface from dust
Apply the 10mm mortar layer on If mortars gets on the surface of the
and dirt, for good accretion of the
each top and side faces of the block blocks, before it hardens
mortar. Level out the base where
and lay it into the correct position. (after ó.5 or 1 hour) brush off
first line of Ventilo blocks will be
Remove excess mortar using the mortar with a soft wired
installed.
a trowel. brushed or hard plastic, do not
Use hand gloves, if blocks are white use metal.
Start the first block laying from the
or bright in color, to prevent dirt or
bottom corner. Apply protective / colour enhancer
stain on block.
coat to blocks. (Water based acrylic
paintcould be used to color the
blocks)
Ventilo
+91 98252 62192 +91 75749 62192
www.prostone.in [email protected]
A Breathable Wall