Image Formation and Representation

Computer Vision
 A Simple model of image formation
• The scene is illuminated by a single source.
• The scene reflects radiation towards the camera.
• The camera senses it via solid state cells (CCD cameras)
 Image formation (cont’d)
• There are two parts to the image formation process:

(1) The geometry, which determines where in the image plane

the projection of a point in the scene will be located.

(2) The physics of light, which determines the brightness of a

point in the image plane.

Simple model: f(x,y) = i(x,y) r(x,y)

i: illumination, r: reflectance
 Let’s design a camera

• Put a piece of film in front of an object - do we get a

reasonable image?
– Blurring - need to be more selective!
 Let’s design a camera (cont’d)

• Add a barrier with a small opening (i.e. aperture) to

block off most of the rays
– Reduces blurring
 “Pinhole” camera model
• The simplest device to form an image of a 3D scene
on a 2D surface.
• Rays of light pass through a "pinhole" and form an
inverted image of the object on the image plane.

center of
projection perspective projection:
(x,y) fX fY
(X,Y,Z) x y
Z Z
f: focal length
 What is the effect of aperture size?
Large aperture: light from the
source spreads across the
image (i.e., not properly
focused), making it blurry!

Small aperture: reduces

blurring but (i) it limits the
amount of light entering the
camera and (ii) causes light
diffraction.
Example: varying aperture size
 Example: varying aperture size (cont’d)

• What happens if we keep

decreasing aperture size?

• When light passes through a

small hole, it does not travel
in a straight line and is
scattered in many directions
(i.e., diffraction)

SOLUTION: refraction
 Refraction
• Bending of wave when it enters a medium where its
speed is different.
 Lens
• Lens duplicate pinhole geometry without resorting to
undesirably small apertures.
– Gather all the light radiating from an object point towards
the lens’s finite aperture .
– Bring light into focus at a single distinct image point.

refraction
 Lens (cont’d)

• Lens improve
image quality,
leading to
sharper images.
 Properties of “thin” lens (i.e., ideal lens)

focal point

• Light rays passing through the center are not deviated.

• Light rays passing through a point far away from the
center are deviated more.
 Properties of “thin” lens (i.e., ideal lens)

focal point

• All parallel rays converge to a single point.

• When rays are perpendicular to the lens, it is called
focal point.
 Properties of “thin” lens

focal point

• The plane parallel to the lens at the focal point is

called the focal plane.
• The distance between the lens and the focal plane is
called the focal length (i.e., f) of the lens.
 Thin lens equation
Assume an object at distance u from the lens plane:

v u
f
object

image
 Thin lens equation (cont’d)
Using similar triangles:

v u
f
y
y’
y’/y = v/u
image
 Thin lens equation (cont’d)
Using similar triangles:

v u
f
y
y’
y’/y = (v-f)/f
image
 Thin lens equation (cont’d)
Combining the equations:

v u
f

1 1 1
+ =
u v f
image
 Thin lens equation (cont’d)
1 1 1
+ =
u v f

“circle of
confusion”

• The thin lens equation implies that only points at distance u from
the lens are “in focus” (i.e., focal point lies on image plane).
• Other points project to a “blur circle” or “circle of confusion”
in the image (i.e., blurring occurs).
 Thin lens equation (cont’d)

focal point 1 1 1
+ =
u v f
f

• When objects move far away from the camera, then

the focal plane approaches the image plane.
 Depth of Field
The range of depths over which the world is approximately
sharp (i.e., in focus).

http://www.cambridgeincolour.com/tutorials/depth-of-field.htm
 How can we control depth of field?
• The size of blur circle is proportional to aperture size.
 How can we control depth of field? (cont’d)

• Changing aperture size

(controlled by diaphragm)
affects depth of field.
– A smaller aperture increases the
range in which an object is
approximately in focus (but
need to increase exposure time).
– A larger aperture decreases the
depth of field (but need to
decrease exposure time).
 Varying aperture size

Large aperture = small DOF Small aperture = large DOF

Another Example

Large aperture = small DOF

 Field of View (Zoom)
• The cone of viewing directions of the camera.
• Inversely proportional to focal length.

f f
Field of View (Zoom)
 Reduce Perspective Distortions
by varying Distance / Focal Length

Small f (i.e., large FOV),

camera close to car

Large f (i.e., small FOV),

camera far from car Less perspective
distortion!
 Same effect for faces

Less perspective
distortion!

wide-angle standard telephoto

Practical significance: we can approximate perspective projection
using a simpler model when using telephoto lens to view a distant
object that has a relatively small range of depth.
Approximating an “affine” camera

Center of projection is at infinity!

 Real lenses

• All but the simplest cameras contain lenses which are actually
comprised of several "lens elements."

• Each element aims to direct the path of light rays such that they
recreate the image as accurately as possible on the digital sensor.
 Lens Flaws: Chromatic Aberration
• Lens has different refractive indices for different wavelengths.
• Could cause color fringing:
– i.e., lens cannot focus all the colors at the same point.
Chromatic Aberration - Example
 Lens Flaws: Radial Distortion

• Straight lines become distorted as we move further away

from the center of the image.
• Deviations are most noticeable for rays that pass through
the edge of the lens.
 Lens Flaws: Radial Distortion (cont’d)

No distortion Pin cushion Barrel

 Lens Flaws: Tangential Distortion

• Lens is not exactly parallel to the imaging plane!

 Human Eye
• Functions much like a camera:
aperture (i.e., pupil), lens, mechanism for focusing (zoom in/out)
and surface for registering images (i.e., retina)
 Human Eye (cont’d)
• In a camera, focusing at various distances is achieved by
varying the distance between the lens and the imaging plane.
• In the human eye, the distance between the lens and the retina
is fixed (i.e., 14mm to 17mm).
 Human Eye (cont’d)
• Focusing is achieved by varying the shape of the lens (i.e.,
flattening of thickening).
 Human Eye (cont’d)
• Retina contains light sensitive cells that convert light
energy into electrical impulses that travel through nerves to
the brain.
• Brain interprets the electrical signals to form images.
 Human Eye (cont’d)
• Two kinds of light-sensitive cells: rods and cone (unevenly
distributed).
• Cones (6 – 7 million) are responsible for all color vision
and are present throughout the retina, but are concentrated
toward the center of the field of vision at the back of the
retina.
• Fovea – special area
– Mostly cones.
– Detail, color sensitivity,
and resolution are highest.
 Human Eye (cont’d)
• Three different types of cones; each type has a special
pigment that is sensitive to wavelengths of light in a
certain range:
– Short (S) corresponds to blue
.

440 530 560 nm.

– Medium (M) corresponds to green

RELATIVE ABSORBANCE (%)

100

– Long (L) corresponds to red S M L

• Ratio of L to M to S cones: 50

– approx. 10:5:1
• Almost no S cones in
400 450 500 550 600 650
the center of the fovea
WAVELENGTH (nm.)
 Human Eye (cont’d)
• Rods (120 million) more sensitive to light than cones but
cannot discern color.
– Primary receptors for night vision and detecting motion.
– Large amount of light overwhelms them,
and they take a long time to “reset”
and adapt to the dark again.
– Once fully adapted to darkness,
the rods are 10,000 times more
sensitive to light than the cones
 Digital cameras
• A digital camera replaces film
with a sensor array.

– Each cell in the array is light-

sensitive diode that converts
photons to electrons

– Two common types

• Charge Coupled Device (CCD)
• Complementary metal oxide
semiconductor (CMOS)

http://electronics.howstuffworks.com/digital-camera.htm
Digital cameras (cont’d)
 CCD Cameras
• CCDs move photogenerated charge from pixel to pixel and convert it to
voltage at an output node.
• An analog-to-digital converter (ADC) then turns each pixel's value
into a digital value.

http://www.dalsa.com/shared/content/pdfs/CCD_vs_CMOS_Litwiller_2005.pdf
 CMOS Cameras
• CMOs convert charge to voltage inside each element.
• Uses several transistors at each pixel to amplify and move the charge
using more traditional wires.
• The CMOS signal is digital, so it needs no ADC.

http://www.dalsa.com/shared/content/pdfs/CCD_vs_CMOS_Litwiller_2005.pdf
 Image digitization

• Sampling: measure the value of an image at a finite

number of points.
• Quantization: represent measured value (i.e., voltage) at
the sampled point by an integer.
Image digitization (cont’d)

Sampling Quantization
What is an image?

8 bits/pixel

255
 What is an image? (cont’d)
• We can think of a (grayscale) image as a function, f, from
R2 to R (or a 2D signal):
– f (x,y) gives the intensity at position (x,y)
f (x, y)

– A digital image is a discrete (sampled, quantized) version of

this function
 Image Sampling - Example
original image sampled by a factor of 2

Images have
been resized
sampled by a factor of 4 sampled by a factor of 8 for easier
comparison
 Image Quantization - Example
• 256 gray levels (8bits/pixel) 32 gray levels (5 bits/pixel) 16 gray levels (4 bits/pixel)

• 8 gray levels (3 bits/pixel) 4 gray levels (2 bits/pixel) 2 gray levels (1 bit/pixel)

 Color Images

• Color images are comprised of three color channels –

red, green, and, blue – which combine to create most
of the colors we can see.

=
Color images

 r ( x, y ) 
f ( x, y )   g ( x, y ) 
 
 b( x, y ) 
 Color sensing in camera: Prism
• Requires three chips and precise alignment.

CCD(R)

CCD(G)

CCD(B)
Color sensing in camera: Color filter array
• In traditional systems, color filters are applied to a single
layer of photodetectors in a tiled mosaic pattern.

Bayer grid
Why more green?

Human Luminance Sensitivity Function

Color sensing in camera: Color filter array

red green blue output

demosaicing
(interpolation)
 Color sensing in camera: Foveon X3
• CMOS sensor; takes advantage of the fact that red, blue
and green light silicon to different depths.

http://www.foveon.com/article.php?a=67
 Alternative Color Spaces
• Various other color representations can be computed
from RGB.
• This can be done for:
– Decorrelating the color channels:
• principal components.
– Bringing color information to the fore:
• Hue, saturation and brightness.
– Perceptual uniformity:
• CIELuv, CIELab, …
 Alterative Color paces
• RGB (CIE), RnGnBn (TV - National Television Standard Committee)
• XYZ (CIE)
• UVW (UCS de la CIE), U*V*W* (UCS modified by the CIE)
• YUV, YIQ, YCbCr
• YDbDr
• DSH, HSV, HLS, IHS
• Munsel color space (cylindrical representation)
• CIELuv
• CIELab
• SMPTE-C RGB
• YES (Xerox)
• Kodak Photo CD, YCC, YPbPr, ...
 Processing Strategy

Red Red

Processing
Green Green
T T-1
Blue Blue
Color Transformation - Examples
Skin color

RGB rg
r

g
 Skin detection

M. Jones and J. Rehg, Statistical Color Models with Application to Skin

Detection, International Journal of Computer Vision, 2002.
 Image file formats
• Many image formats adhere to the simple model shown below
(line by line, no breaks between lines).
• The header contains at least the width and height of the image.
• Most headers begin with a signature or “magic number”
(i.e., a short sequence of bytes for identifying the file format)
 Common image file formats

• GIF (Graphic Interchange Format) -

• PNG (Portable Network Graphics)
• JPEG (Joint Photographic Experts Group)
• TIFF (Tagged Image File Format)
• PGM (Portable Gray Map)
• FITS (Flexible Image Transport System)
 PBM/PGM/PPM format
• A popular format for grayscale images (8 bits/pixel)
• Closely-related formats are:
– PBM (Portable Bitmap), for binary images (1 bit/pixel)
– PPM (Portable Pixelmap), for color images (24 bits/pixel)

• ASCII or binary (raw) storage

ASCI

Binary