8.

0 THHN 25mmØ RSC

CASURECO SERVICE
ELECTRICAL LEGENDS: ENTRANCE

SECONDARY RACK
SYMBOL DESCRIPTION ENTRANCE CAP
SYMBOL DESCRIPTION
PVC STRAP
INCANDESCENT LAMP S1 SINGLE POLE SWITCH 1
SERVICE ENTRANCE S2 TWO GANG SWITCH PRIVATE POLE

M KILOWATTHOUR METER S3 THREE GANG SWITCH KWH METER 1

CIRCUIT BREAKER POWER CIRCUIT LINE

1.82
1.65
CONVENIENCE OUTLET N CIRCUIT HOMERUN FFL
NGL
40AT
SWITCH LEG PANEL BOARD

SERVICE ENTRANCE DETAILS LIGHTING 1 15AT 15AT 2 LIGHTING

OUTLET OUTLET
1
LIGHTING 3 4 CONVINIENCE
20AT 20AT
OUTLET OUTLET
ELECTRICAL SPECIFICATIONS CONVINIENCE 6
5 30AT 30AT REFRIGERATOR 2
OUTLET
01. ALL ELECTRICAL WORKS SHALL BE DONE IN 7
ACCORDANCE WITH THE RULES AND REGULATIONS OF THE RANGE 7 30AT 30AT 8 ACU
LATEST EDITION OF THE PHILIPPINE ELECTRIC CODE,
APPLICABLE ORDINANCES OF THE LOCAL GOVERNMENT AND
WITH THE REQUIREMENTS OF THE LOCAL COMPANY POWER. SPARE 9 20AT 20AT 10 SPARE
1 1
02. METALLIC ENCLOSURES, RACEWAY AND ELECTRICAL
EQUIPMENT SHALL BE GROUNDED.

03. MINIMUM SIZE IF WIRE SHALL BE 3.5 mm² THHN AND THE
THE SITE
MINIMUM SIZE IF CONDUIT SHALL BE 20mm DIAMETER, UNLESS GROUND SYSTEM
OTHERWISE INDICATED IN THE PLAN.

04. WHEREVER REQUIRED AND NECESSARY, PULL BOXES

AND JUNCTION BOXES OF PROPER SIZES SHALL BE INSTALLED
AT CONVENIENT AND INCONPICUOUS LOCATIONS ALTHOUGH
SUCH BOXES ARE NOT SHOWN ON THE PLANS NOR MENTIONED
IN THE SPECIFICATIONS. 19 7

05. ALL LIGHTING CIRCUIT HOMERUNS AND CONVENIENCE

OUTLETS SHALL BE WIRED WITH NO LESS THAN 3.5mm² THHN IN RISER DIAGRAM
SIZE, ALL 20 AND 30AMP. CIRCUIT HOMERUN TO PANEL BOARD
MORE THAN 30 MTS. IN LENGTH SHALL BE WIRED WITH NO LESS
THAN 5.5mm² THHN, UNLESS OTHERWISE INDICATED ON THE
PLAN. 1

06. THE CONTRACTOR SHALL VERIFY AND ORIENT THE

ACTUAL LOCATION OF SERVICE ENTRANCE FOR CONNECTION
TO POWER LOCAL SERVICE POINT.
VICINITY MAP
07. ALL WIRING SHALL BE INSTALLED IN STANDARD
MOLDFLEX OR PVC ELECTRICAL CONDUITS RUN EMBEDDED SCHEDULE OF LOADS:
INSIDE THE CONCRETE AND THE HOLLOW BLOCKS
STRUCTURES, SLABS, COLUMNS, WALLS, PARTITIONS AND
SWITCHES
INSIDE THE CEILING SPACES, WHERE THE USE OF CONCEALED
CKT LOAD DESCRIPTION NO. OF WATTS VOLTS AMPS PROT TYPES OF SIZE OF SIZE OF
CONDUIT WIRING IS IMPRACTICABLE SURFACE METAL, PVC
MOLDING MAY BE USED.\ OUTLETS S1 S2 S3 WIRE WIRE CONDUIT 1

08. ELECTRICAL WORKS SHALL BE DONE UNDER THE DIRECT

AND FULL SUPERVISION OF A DULY LICENSED ELECTRICAL 1 LIGHTING OUTLET 8 1 2 1 800 230 3.48 15AT THHN 2-2.0 mm² 25mmØ
ENGINEER OR REGISTERED MASTER ELECTRICIAN.
7
09. PANEL BOARD SHALL BE COMPLETE WITH BUS, 2 LIGHTING OUTLET 7 3 2 - 700 230 3.04 15AT THHN 2-2.0 mm² 25mmØ
ENCLOSURE AND TRIM, COMPLETE AND MOLDED CASE CIRCUIT
BREAKER, WITH RATING AS INDICATED. PROVIDE A TYPED
CIRCUIT DIRECTORY. 3 LIGHTING OUTLET 14 6 4 - 1,400 230 6.09 15AT THHN 2-2.0 mm² 25mmØ

10. ALL ELECTRICAL DEVICES AND EQUIPMENT EXPOSED TO

WEATHER SHALL BE WEATHERPROOF. 4 CONVENIENCE OUTLET 7 - - - 1,260 230 5.48 20AT THHN 2-3.5 mm² 25mmØ

11. ELECTRICAL SERVICE FOR THE PREMISES SHALL BE 220V,

1 PHASE, 2 WIRE. 5 CONVENIENCE OUTLET 7 - - - 1,260 230 5.48 20AT THHN 2-3.5 mm² 25mmØ
12. COORDINATE WITH MECHANICAL CONTRACTOR FOR
EQUIPMENT REQUIREMENTS AND PROVIDE ALL WIRING 1
6 REFRIGERATOR 1 - - - 1,500 230 6.52 30AT THHN 2-3.5 mm² 25mmØ
EQUIPMENT REQUIRED. 1
13. TEST: THE FOLLOWING SHALL BE TESTED IN PRESENCE
- - -
COMPUTATION
7 RANGE 1 1,500 230 6.52 30AT THHN 2-3.5 mm² 25mmØ
OF ENGINEER, AND RESULSUBMITTED TO ENGINEER FOR
APPROVAL. C. GROUND RESISTANCE (IF THERE IS GROUND OF LOADS:
FLOOR)
8 ACU 1 - - - 1,500 230 6.52 30AT THHN 2-3.5 mm² 25mmØ
14. THE DRAWINGS AND SPECIFICATIONS ARE MEANT TO BE IT = WATTAGE
COMPLIMENTARY TO EACH OTHER AND WHAT IS REQUIRED BY
ONE SHALL BE BINDING IF CALLED BY BOTH. ANY APPARENT 9 SPARE 1,500 230 6.52 20AT THHN 2-3.5 mm² 25mmØ VOLTAGE GROUND FLOOR LIGHTING LAYOUT
CONFLICT BETWEEN THE DRAWINGS AND SPECIFICATIONS, AND
ANY CONTROVERSIES OR UNCLEAR POINTS IN EITHER, SHALL
BE REFERRED TO ELECTRICAL CONSULTANTS OR DESIGNER 10 SPARE 1,500 230 6.52 20AT THHN 2-3.5 mm² 25mmØ IT = 12,920
FOR THE FINAL DESIGN. 230 V
15. ALL REVISION OR ADDITIONAL WORKS ON ELECTRICAL TOTAL 46 10 8 1 12,920 230 56.17
PLANS SHOULD CONSULTED TO THE DESIGNER (P.E.E.)
IT = 56.17 AMP

CERTIFIED BY: PROJECT TITLE AND LOCATION: APPROVED BY: REVISIONS: SHEET CONTENT: SHEET NO.

E-1
PROPOSED TWO-STOREY RESIDENTIAL BUILDING AS SHOWN
ALVIN KASILAG
7 9
BRGY. IMPIG, SIPOCOT, CAMARINES SUR OWNER