Scribd
Upload
45 views11 pages

Mainboard MCU

The document provides instructions for upgrading the firmware of the MCU and USB for a printer with an up-down capping system. It lists the newest versions, applicable models, steps to check the current version, perform the upgrade, and verify the upgrade was successful.

Uploaded by

José Ramón Torres
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views11 pages

Mainboard MCU

The document provides instructions for upgrading the firmware of the MCU and USB for a printer with an up-down capping system. It lists the newest versions, applicable models, steps to check the current version, perform the upgrade, and verify the upgrade was successful.

Uploaded by

José Ramón Torres
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 11

Instruction of MCU and USB upgrading

A: Firmware Upgrade for the printer with up-down capping system.

1) The newest versions of main-board MCU and USB firmware:


MCU: 5.1.1
USB : 5.1.6

2) The applicable models:


All of the models with up-down capping system.

3) Click to , then click to ,


Instruction of MCU and USB upgrading

To check which version of Mainboard MCU and USB firmware are

they.

If they are the newest version, then no need to upgrade them.

4) Before upgrading, please turn off the and power, then


make sure the computer’s USB and the machine’s USB both connect

well.

5) Please turn on the power, click to ,then click to the


Instruction of MCU and USB upgrading

IF it informs”Connect OK”, it means the successful connection

between the computer and the mainboard.

6) For upgrading of mainboard MCU:


Instruction of MCU and USB upgrading

 Please click to , and then click to ( )

 Please find out the newest MCU firmware: MB5.1.1.bin,


Instruction of MCU and USB upgrading

 Please click to ( )

 Beneath is the progress information:


Instruction of MCU and USB upgrading

 When informs “Update Firmware Success!”, upgrading finished.

7) For upgrading the USB firmware:

 Please pull off the USB protect cap


Instruction of MCU and USB upgrading

 Please click to , then click to

 Please find out the newest USB firmware: USB5.1.6icc,


Instruction of MCU and USB upgrading

 Please click to
Instruction of MCU and USB upgrading

 Beneath is the progress information:

 When informs “Update Firmware Success!”, upgrading finished.


Instruction of MCU and USB upgrading

8) After finishing upgrading, turn off the , turn off the power

supply, install the USB protect cap.

9) Then please turn on the power supply, turn on the , after

successful connection, click to


Instruction of MCU and USB upgrading

If shown MCU: 5.1.1USB : 5.1.6 , updating finished.

You might also like