Ricoh SP 150 Series MFP Technical Buletin
Ricoh SP 150 Series MFP Technical Buletin
Ricoh SP 150 Series MFP Technical Buletin
Reissued: 08-Jul-16
Model: Reveil-MF1 Date: 25-May-16 No.: RM291001b
RTB Reissue
The items in bold italics have been corrected or added.
Subject: Firmware Release Note: Main Prepared by: Y. Miyamoto
From: 1st Tech Service Sect., MFP/Printer Tech Service Dept.
Classification: Troubleshooting Part information Action required
Mechanical Electrical Service manual revision
Paper path Transmit/receive Retrofit information
Product Safety Other (Firmware) Tier 2
This RTB has been issued to announce the firmware release information for the Main.
This RTB has been issued to announce the firmware release information for the
CE TOOL.
This RTB has been issued to announce the firmware release information for the
Main.
Number of
Dot coverage ratio range
pages
Example
Number of
Dot coverage ratio range
pages
Note: 1st~7th indicates the order from Left to Right of the eight digit numbers for each
dot coverage ratio range.
Note: The example shown above shows only two digits for each range, but in the actual
System Settings, there will be eight digits displayed for each range.
(8 digits x 7 ranges = 56 digits in total)
Technical Bulletin PAGE: 1/5
Model: Rev-MF1 Date: 23-Mar-18 No.: RM291004
Subject: FSM correction – The replacement procedure for Prepared by: A. Shigeta
scanner unit -
From: Tech. Support Sec., Product Marketing Dept.
Classification: Troubleshooting Part information Action required
Mechanical Electrical Service manual revision
Paper path Transmit/receive Retrofit information
Product Safety Other (New model) Tier 2
The procedure for replacing to a new scanner unit was revised. Before replacement, you
have to obtain the PC software “48L3_ABC_Maintain” with the link below to conduct the
CIS calibration.
ftp://10.62.17.218/data/Release_docs/15A/Model_ReveilP1MF1/apli
After installing a new scanner unit, the software adjustment is required since this
machine has no scanner home position.
Using the software in the link above, the machine can detect the home position
with a certain algorithm.
If this adjustment is not fully conducted, SC1001 may occur in a case that a home
position of a new scanner unit is quite different from the old one.
The CE Tool for this model cannot conduct the home position adjustment.
Scanner Unit
• To remove the paper feed guide [A], release the right linkage first.
7. Open the scanner unit [A] and remove the guide rail [B]. ( x1)
9. Remove the laser unit from the scanner unit [A]. ( x4)
• After installing to a new scanner unit, following adjustment with the PC software
“48L3_ABC_Maintain” is required.
3. Adjustment tool will open (You can see the following screen).
Technical Bulletin PAGE: 4/5
Model: Rev-MF1 Date: 23-Mar-18 No.: RM291004
5. Press the Start button on the tool (Adjustment of scanner home position sensor will
automatically start).
ftp://10.62.17.218/data/Release_docs/15A/Model_ReveilP1MF1/apli