Scribd Logo
Upload

Welcome to Scribd!

  • 207 views

    Bosch Edc17c45 Irom tc1767 Nissan

    Uploaded by

    Autotronica Chosica
    The document provides instructions for connecting to the Bosch EDC17C45 engine control unit in a Nissan vehicle using the Trasdata cable F32GN037C/D, including connecting the power and boot/configuration pins.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Bosch Edc17c45 Irom tc1767 Nissan

    Uploaded by

    Autotronica Chosica
    207 views4 pages
    The document provides instructions for connecting to the Bosch EDC17C45 engine control unit in a Nissan vehicle using the Trasdata cable F32GN037C/D, including connecting the power and boot/configuration pins.

    Original Title

    bosch_edc17c45_irom_tc1767_nissan

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    The document provides instructions for connecting to the Bosch EDC17C45 engine control unit in a Nissan vehicle using the Trasdata cable F32GN037C/D, including connecting the power and boot/configuration pins.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    207 views4 pages

    Bosch Edc17c45 Irom tc1767 Nissan

    Uploaded by

    Autotronica Chosica
    The document provides instructions for connecting to the Bosch EDC17C45 engine control unit in a Nissan vehicle using the Trasdata cable F32GN037C/D, including connecting the power and boot/configuration pins.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 4

    BOSCH EDC17C45 IROM TC1767 NISSAN

    plugin 657
    BOSCH EDC17C45 IROM TC1767 NISSAN
    BOSCH EDC17C45 IROM TC1767 NISSAN

    DIRECT CONNECTION
    In order to connect to the ECU use the CABLE F32GN037C/D.
    Make sure that the POWER led (red) on Trasdata is ON.

    ECU CONNECTOR

    To the power feeding pins 5,19,56 (+12V) you can connect both wires red (VECU) and orange
    VKEY) of the F32GN037C/D cable, they both have 12V signal
    BOSCH EDC17C45 IROM TC1767 NISSAN

    BOOT/CNF1 CONNECTION
    Connect the GREY and BLUE wires of the cable F32GN037C/D as described here below

    For a correct connection on the BOOT pin of the microprocessor pad you should /we suggest to
    use the specific micro clamps supplied in the kit C34ACD012.
    Warning: do not use other types of micro clamps, only these are completely insulated, otherwise
    the risk is to damage the microprocessor.

    You might also like