0% found this document useful (0 votes)
25 views3 pages

1d. Nortons Theorem

Norton's theorem states that any network connected between two terminals can be replaced by a single current source in parallel with a single resistor. The current source value is equal to the short-circuit current between the terminals, and the resistor value is the same as that of the equivalent Thevenin circuit. This allows complex networks to be simplified for current analysis by reducing them to a basic parallel circuit.

Uploaded by

hsejmal12345
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
25 views3 pages

1d. Nortons Theorem

Norton's theorem states that any network connected between two terminals can be replaced by a single current source in parallel with a single resistor. The current source value is equal to the short-circuit current between the terminals, and the resistor value is the same as that of the equivalent Thevenin circuit. This allows complex networks to be simplified for current analysis by reducing them to a basic parallel circuit.

Uploaded by

hsejmal12345
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Norton’s Theorem

Norton’s theorem is used to simplify a network in terms of currents instead of voltages.


For current analysis, this theorem can be used to reduce a network to a simple parallel
circuit with a current source, which supplies a total line current that can be divided
among parallel branches.
Norton’s theorem states that any network connected to terminals a and b
can be replaced by a single current source I N in parallel with a single resistance RN

I N is equal to the short-circuit current through the a b terminals (the current

that the network would produce through a and b with a short circuit across these two
terminals). The value of the single resistor is the same for both the Norton and Thevenin
equivalent circuits.
a
a
Linear IN RN External
network network

b
b

Norton equivalent, IN and parallel RN

This direction must be the same as the current produced by the polarity of the
corresponding voltage source. Remember that a source produces current flow out from
the positive terminal.
Consider two loop network.

R1 R3 a a
 

V R2 RL  IN RN RL
IL IL
 
b b
RN
Then I L  IN
RN  RL
Norton Current  I N 
R1 R3 a
 V
I 
I R1  R2 R3  R2  R3 
V R2 IN
R2
IN  I
R2  R3

b
Norton Resistance  RN 

R1 R3 a

R1 R2
R2 RN   R3
R1  R2

b
We therefore see that the Thevenin equivalent circuit corresponds to the Norton
equivalent circuit. So a general voltage source with a series resistance can be converted to
an equivalent current source with the same resistance in parallel . Divide the general
source V by its series resistance R to find the value of I for the equivalent current

VTh
source shunted by the same resistance R; that is I N  .
RTh
We therefore see that Thevenin equivalent circuit corresponds to the Norton equivalent
circuit .

RTh a
a

VTh IN RN

b b
Thevenin circuit Norton circuit

Equivalent circuits
We can also see that the Norton equivalent circuit corresponds to the Thevenin equivalent
circuit. a RTh a
 

IN RN RL  VTh RL
IL IL
 
b b
where VTh  I N RN (open circuit voltage across ab)

and RTh  RN (open the current source and measure the equivalent resistance across ab)
Example: Draw Norton equivalent circuit for the circuit shown in figure below and find
current I across 7  resistance. 3 7

12V 6 I 7

Solution. : 3 7

I
12V 6 I 7
IN RN 7

3 7 3 7

I
12V 6 IN 6 RN

12 52 6 52 8 3 6
I   A , IN    A RN   7  9
6  7 27 6  7 27 9 3 6
3
67
RN 9 8 1
Thus I  IN    A
RN  7 97 9 2

You might also like