Scribd
Upload
55 views2 pages

Medium User Manual

The Medium V1.0 is a scrolling indicator for buildings up to 16 floors. It contains arrow buttons and two push buttons to program each floor and set options like code input, reset, scrolling speed, and illumination intensity. It operates on 24VDC power and measures 10.4cm x 6.4cm. Setup options allow customizing floor digits and resetting and other parameters.

Uploaded by

Ali KENAAN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
55 views2 pages

Medium User Manual

The Medium V1.0 is a scrolling indicator for buildings up to 16 floors. It contains arrow buttons and two push buttons to program each floor and set options like code input, reset, scrolling speed, and illumination intensity. It operates on 24VDC power and measures 10.4cm x 6.4cm. Setup options allow customizing floor digits and resetting and other parameters.

Uploaded by

Ali KENAAN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Medium V1.

The “Medium” is a scrolling indicator for the buildings with 16 floors


maximum, and contains arrows’ input and 2 push buttons to program
each floor, set the code input (gray or binary), reset the indicator, set
the speed of scrolling and the intensity of illumination.

Beirut- Mreijeh -beside Bank Sadirat Iran, TEL: 03-968115/01-467166.


FACEBOOK: LS Electronics, Email:[email protected]
Technical Data
supply 24vdc( tolerance : ±25%), 120mA
A,B,C,D High level input(+24vdc)
Arrow Up, Arrow Down Low level input(0vdc)
Dimensions of pcb Height × Width = 10.4cm×6.4cm
Dimensions of Display screen Height × Width × Depth = 3.91cm×4.4cm×0.8cm
Setup:
1) To enter the setup mode, press the push buttons *INC* and *OK* for 1 sec
then release your hand when the display screen is off.
2) Use button *INC* to change parameter or content of parameter.
3) Use button *OK* to save change in parameter, or access into parameter.
4) When you reach the character “EX” press *OK* to exit setup.

Parameter Description Range Default


In this parameter you can -5,-4,-3,-2,-1,0,1,2,3,4,5,6,
F0,F1,F2 From 0
change the display digits for 7,8,9,10,11,12,13,14,15,GF,M1,
..….,F14,F15
each floor. M2,M3,B1,B2,B3 to 15
 Reset the indicator from
x to (x+15).
 If you enter in this
RS parameter unintentionally x=0,-1,-2,-3,-4,-5,EX 0
you can exit, without reset the
indicator, by pressing “OK”
when reaching “EX”.
Cd Input code (binary or gray). BN(binary) - GR(gray) GR
Speed of scrolling (1 is the
SP
fastest)
1,2,3,4,5,6,7 1
Intensity of illumination(4 is
LT the highest)
1,2,3,4 3
EX Exit setup none none

Attention: Please do not remove the label, to keep your product’s guarantee.

Beirut- Mreijeh -beside Bank Sadirat Iran, TEL: 03-968115/01-467166.


FACEBOOK: LS Electronics, Email:[email protected]

You might also like