Scribd
Upload
58 views2 pages

ISl 9520

The ISL9520 is an integrated narrow VDC regulator and battery charger controller that operates over the SMBus. It regulates system voltage, controls battery charging, and provides monitoring outputs. Key features include programmable system voltage and current limits, efficient operation down to light loads, and trickle charging for deeply discharged batteries. Applications include notebooks, tablets, and other portable devices with rechargeable batteries.

Uploaded by

Tecnico Genio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
58 views2 pages

ISl 9520

The ISL9520 is an integrated narrow VDC regulator and battery charger controller that operates over the SMBus. It regulates system voltage, controls battery charging, and provides monitoring outputs. Key features include programmable system voltage and current limits, efficient operation down to light loads, and trickle charging for deeply discharged batteries. Applications include notebooks, tablets, and other portable devices with rechargeable batteries.

Uploaded by

Tecnico Genio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

DATA SHORT

To request the full datasheet, please visit www.intersil.com/products/isl9520

ISL9520 FN8348
Narrow VDC Regulator/Charger with SMBus Interface Rev 1.00
March 6, 2013

The ISL9520 is a highly integrated Narrow VDC system voltage


regulator and battery charger controller. Operating parameters
Features
are programmable over the System Management Bus (SMBus). • ±0.5% system voltage accuracy (-10°C to +100°C)
The ISL9520 is designed for applications where the system • ±3% accurate input current limit (-10°C to +100°C)
power source is either the battery pack or the output of the
• ±3% accurate battery charge current limit
regulator/charger. This makes the max voltage to the system
equal to the max battery voltage instead of the max adapter • Variable switching frequency at light load conditions for
voltage. The ISL9520 also includes a patented system to control higher efficiency
trickle charging deeply discharged batteries while maintaining • Fixed frequency operation at higher loads
system voltage at a user defined minimum. High efficiency is - Fixed frequency mode can be forced by an external pin
achieved with a DC/DC synchronous-rectifier buck converter,
equipped with diode emulation and variable switching • Trickle charge system for deeply discharged batteries
frequency for enhanced light load efficiency and AC-adapter - Automatic trickle charge current (256mA)
boosting prevention. The ISL9520 can charge two, three, or - Holds minimum voltage to system
four series connected Lithium-ion cells, at up to 8A charge
current. Default settings for 2-, 3- or 4-cell operation at • SMBus 2-wire serial interface
power-up are selected by an external pin. Integrated MOSFET • Default system voltage values for 2-cell, 3-cell or 4-cell
drivers and bootstrap diode result in fewer components and operation selected by an external pin
smaller implementation area. Low offset current-sense
• Adapter in-rush FET control
amplifiers provide high accuracy.
• Adapter isolation FET control
The ISL9520 provides an open drain digital output that
indicates the presence of the AC-adapter. The ISL9520 also • Battery short circuit protection
provides an analog output that indicates the battery discharge • Fast system-load transient response
current and an output that indicates the adapter current.
• Monitor outputs
Applications - Adapter and battery discharge current
- AC-adapter present indicator
• Ultrabooks
• 11-bit max system voltage setting
• Notebook computers
• 7-bit min system voltage setting
• Tablet PCs
• 6-bit charge current setting
• Portable equipment with rechargeable batteries
- Over 8A battery charger current
Related Literature • 6-bit adapter current setting
• See AN1826, “ISL9520EVAL1Z Evaluation Board Setup - Over 8A adapter current
Procedure” for evaluation board setup instructions • +9V to +22V adapter voltage range
• VOUT from 2.5V to 19V in 16mV increments
• High efficiency at loads < 0.5W for Energy Star 2013 and
ErP lot 6
- 250mW from adapter with 170mW to the load
• Turbo mode support
- Pulse-by-pulse response to limit adapter current
- BGATE on in Turbo mode
• Pb-Free (RoHS compliant)

FN8348 Rev 1.00 Page 1 of 2


March 6, 2013
ISL9520

© Copyright Intersil Americas LLC 2013. All Rights Reserved.


All trademarks and registered trademarks are the property of their respective owners.

For additional products, see www.intersil.com/en/products.html


Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil may modify the circuit design and/or specifications of products at any time without notice, provided that such
modification does not, in Intersil's sole judgment, affect the form, fit or function of the product. Accordingly, the reader is cautioned to verify that datasheets are
current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its
subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com

FN8348 Rev 1.00 Page 2 of 2


March 6, 2013

You might also like