01 Introduction 009
01 Introduction 009
0 SP2 Introduction
Introduction
Content
Introduction 1
General ................................................................................................................... 2
Documentation structure ......................................................................................... 3
Guide ....................................................................................................................... 5
General
This is the Engineering Manual for CEMAT V9.0 SP2. It should support you in performing
the work required to configure your plant.
The Engineering Manual is part of a comprehensive CEMAT V9.0 SP2 documentation
which consists of the volumes listed below.
Engineering
Manual
Reference Manuals
System Objects
After the installation of CEMAT V9.0 SP2 the CEMAT documentation is available as PDL in
directory D:\CEMAT_CS\Docu
On the following pages you will find the content of each manual.
Documentation structure
The manuals contain the following chapters:
Engineering Manual
1 Introduction
2 Preparations
3 Installation of a PCS 7 Project
4 Assignments
5 Engineering Examples
6 PLC Engineering
7 AS-AS Coupling
8 OS Engineering
9. Engineering Tools
10 Engineering Check List
11
12
13
14 Tips&Tricks
15 Update Information
Reference - System
1 Introduction
2 Cemat System Architecture
3
4
5
6
Reference - Objects
1 Introduction
2 General
3 Unidirectional Drive
4 Bi-Directional Drive
5 Damper
6 Valve
7 Adapt
8 Annunciation Module
9. Annunciation Module with 7 Alarms
10 Measuring Value
11 Measured Value Integrator
12
13
14 Silopilot
15 Group Module
16 Route Module
17 Selection
18 Interlock with 2 inputs
19 Interlock with 4 inputs
20 Interlock with 8 inputs
21 Interlock
22 Interlock 5
23
24 PID Controller
25 PID Controller with 3 Parameter sets
26
27 CNT-Module
28 RT-Module
29
30 Analog Value Selection
31 Adapt to Simocode PRO
32 Adapt to Simocode (advanced)
33 Robicon
34 Sinamics
35
36
37
38 Bool Variable for TIS
39 Integer Variable for TIS
40 String Variable for TIS
Guide
The current manual is divided into the topic areas: Installation and Engineering.
The engineering of CEMAT plants is done with the Engineering Tool PCS 7. With PCS 7 the
following steps are carried out.
- Configuring the hardware
- Creation of the PLC programs, including logic diagram (CFC) and documentation
- Transferring the PLC/OS Connection data
- Engineering of the Operator Interface in WinCC