2

1
PNAS LaTeX template for preparing invited 63
64
3
4 submissions on Overleaf 65
66
5 67
6 Author Onea,c,1 , Author Twob,1,2 , and Author Threea 68
7 This manuscript was compiled on May 22, 2023 69
8 70
9 71
Authors drafting perspectives should provide an abstract of no more
10 72
than 250 words in a single paragraph. Abstracts should explain to the
11 73
general reader the major contributions of the article. References in
12 74
the abstract must be cited in full within the abstract itself and cited in
13 75
the text.
14 76
15 Keyword 1 | Keyword 2 | Keyword 3 | ... 77
16 78
17 This PNAS journal template is provided to help you write your work 79
18 in the correct journal format. Instructions for use are provided 80
19 below. 81
20 Note: please start your introduction without including the word 82
21 “Introduction” as a section heading (except for math articles in 83
22 the Physical Sciences section); this heading is implied in the first 84
23 paragraphs. 85
24 86
25
26
27
28
29
30
31
Guide to using this template on Overleaf

FT
Please note that whilst this template provides a preview of the
typeset manuscript for submission, to help in this preparation, it will
not necessarily be the final publication layout. For more detailed
information please see the PNAS Information for Authors.
If you have a question while using this template on Overleaf,
Fig. 1. Placeholder image of a frog with a long example legend to show justification
setting.
87
88
89
90
91
92
93
RA
please use the help menu (“?”) on the top bar to search for help
32 94
and tutorials. You can also contact the Overleaf support team at
33 95
any time with specific questions about your manuscript. References. References should be cited in numerical order as they
34 96
35
appear in text; this will be done automatically via bibtex, e.g. (1) 97
Author Affiliations. Include department, institution, and complete and (2–5). All references cited in the main text should be included
36 98
address, with the ZIP/postal code, for each author. Use lower in the main manuscript file.
37 99
case letters to match authors with institutions, as shown in the
38 100
example. PNAS strongly encourages authors to supply an ORCID
D

39 Data Archival. PNAS must be able to archive the data essential to 101
identifier for each author. Individual authors must link their ORCID a published article. Where such archiving is not possible, deposi-
40 102
account to their PNAS account at www.pnascentral.org. For proper tion of data in public databases, such as GenBank, ArrayExpress,
41 103
authentication, authors must provide their ORCID at submission Protein Data Bank, Unidata, and others outlined in the Information
42 104
and are not permitted to add ORCIDs on proofs. for Authors, is acceptable.
43 105
44 106
Submitting Manuscripts. All authors must submit their articles at
45
PNAScentral. If you are using Overleaf to write your article, you Language-Editing Services. Prior to submission, authors who 107
46
can use the “Submit to PNAS” option in the top bar of the editor believe their manuscripts would benefit from professional editing 108
47
window. are encouraged to use a language-editing service (see list at 109
48 https://www.pnas.org/author-center/language-editing). PNAS does 110
49 Format. This template is intended for authors writing invited not take responsibility for or endorse these services, and their use 111
50 commentaries or perspectives. The format for these article types has no bearing on acceptance of a manuscript for publication. 112
51 may vary, but an abstract is required for perspectives. Please be 113
52 sure to include the title, author line and author affiliations, keywords, Digital Figures. EPS, high-resolution PDF, and PowerPoint are pre- 114
53 acknowledgments, and references. Other sections or headings are ferred formats for figures that will be used in the main manuscript. 115
54 permitted as needed. 116
55 117
Author affiliations: a Affiliation One; b Affiliation Two; c Affiliation Three
56 Manuscript Length. Commentary text and references should not 118
57 exceed 14,000 characters (including spaces). PNAS encourages 119
58 the use of a single color figure or table since they help summarize Please provide details of author contributions here. 120
59 the article for scientists outside the immediate field of the paper. Please declare any competing interests here. 121
60 Perspectives may be up to 9 journal pages, inclusive of abstract, 1
A.O.(Author One) contributed equally to this work with A.T. (Author Two) (remove if 122
61 figures, and references. The standard format for perspectives is not applicable). 123
2
62 relaxed, so nonstandard headings are permitted. To whom correspondence should be addressed. E-mail: author.twoemail.com 124

www.pnas.org/cgi/doi/10.1073/pnas.XXXXXXXXXX PNAS — May 22, 2023 — vol. XXX — no. XX — 1 of 3

125 187
126 188
127 189
128 190
129 191
130 192
131 193
132 194
133 195
134 196
135 197
136 198
137 199
138 200
139 201
140 202
141 203
142 204
143 205
144 206
145 207
146 208
147 209
148 210
149
150
151
152
153
154
FT Fig. 2. This legend would be placed at the side of the
figure, rather than below it.
211
212
213
214
215
216
RA
155 217
156 Authors may submit PRC or U3D files for 3D images; these must the \begin{figure*}...\end{figure*} environment. Figures 218
157 be accompanied by 2D representations in TIFF, EPS, or high- wider than one column should be sized to 11.4 cm or 17.8 cm wide. 219
158 resolution PDF format. Color images must be in RGB (red, green, 220
159 blue) mode. Include the font files for any text. Tables. Tables should be included in the main manuscript file and 221
160 Images must be provided at final size, preferably 1 column should not be uploaded separately. 222
161 width (8.7cm). Figures wider than 1 column should be sized to 223
162 11.4cm or 17.8cm wide. Numbers, letters, and symbols should be Single column equations. Authors may use 1- or 2-column 224
D

163 no smaller than 6 points (2mm) and no larger than 12 points (6mm) equations in their article, according to their preference. 225
164 after reduction and must be consistent. To allow an equation to span both columns, use the 226
165 Figures and tables should be labelled and referenced in the 227
\begin{figure*}...\end{figure*} environment mentioned
166 standard way using the \label{} and \ref{} commands. 228
above for figures.
167 229
Figure 1 shows an example of how to insert a column-wide Note that the use of the widetext environment for equations is
168 230
figure. To insert a figure wider than one column, please use not recommended, and should not be used.
169 231
170 232
171 (x + y)3 = (x + y)(x + y)2 233
172 2 2 234
= (x + y)(x + 2xy + y ) [1]
173 235
174 = x3 + 3x2 y + 3xy 3 + x3 . 236
175 237
176 238
177 Supporting Information Appendix (SI). Authors should submit 239
Table 1. Comparison of the fitted potential energy surfaces and ab
178 SI as a single separate SI Appendix PDF file, combining all text, initio benchmark electronic energy calculations 240
179 figures, tables, movie legends, and SI references. PNAS will 241
180 publish SI uncomposed, as the authors have provided it. Additional Species CBS CV G3 242
181 details can be found here: policy on SI. The PNAS Overleaf SI 1. Acetaldehyde 0.0 0.0 0.0 243
182 template can be found here. Refer to the SI Appendix in the 2. Vinyl alcohol 9.1 9.6 13.5 244
183 manuscript at an appropriate point in the text. Number supporting 3. Hydroxyethylidene 50.8 51.2 54.0 245
184 figures and tables starting with S1, S2, etc. 246
185 nomenclature for the TSs refers to the numbered species in the table. 247
186 248

2 of 3 — www.pnas.org/cgi/doi/10.1073/pnas.XXXXXXXXXX Lead author last name et al.

249 Authors who place detailed materials and methods in an SI Legends should be included in the SI Appendix file. All movies 311
250 Appendix must provide sufficient detail in the main text methods to should be submitted at the desired reproduction size and length. 312
251 enable a reader to follow the logic of the procedures and results and Movies should be no more than 10 MB in size. 313
252 also must reference the SI methods. If a paper is fundamentally 314
253 a study of a new method or technique, then the methods must be 315
254 described completely in the main text. 316
255 Acknowledgments 317
SI Datasets. Supply .xlsx, .csv, .txt, .rtf, or .pdf files. This file type
256 318
will be published in raw format and will not be edited or composed.
257 319
Please include your acknowledgments here, set in a single
258 320
SI Movies. Supply Audio Video Interleave (avi), Quicktime (mov), paragraph. Please do not include any acknowledgments in the
259 321
Windows Media (wmv), animated GIF (gif), or MPEG files. Movie Supporting Information, or anywhere else in the manuscript.
260 322
261 323
262 1 M Belkin, P Niyogi, Using manifold stucture for partially labeled classification in Advances in neural information processing systems. pp. 929–936 (2002). 324
2 P Bérard, G Besson, S Gallot, Embedding riemannian manifolds by their heat kernel. Geom. & Funct. Analysis GAFA 4, 373–398 (1994).
263 325
3 RR Coifman, et al., Geometric diffusions as a tool for harmonic analysis and structure definition of data: Diffusion maps. Proc. Natl. Acad. Sci. United States Am. 102, 7426–7431 (2005).
264 4 RJF Thomas, “Enamel defects, well-being and mortality in a medieval Danish village,” PhD thesis, Pennsylvania State University, University Park, PA (2003). 326
265 5 TM Toolan, “Advances in Sliding Window Subspace Tracking,” M.Sc. thesis, University of Rhode Island, Kingston, RI (2005). 327
266 328
267 329
268 330
269 331
270 332
271 333
272 334
273
274
275
276
277
278
FT 335
336
337
338
339
340
RA
279 341
280 342
281 343
282 344
283 345
284 346
285 347
286 348
D

287 349
288 350
289 351
290 352
291 353
292 354
293 355
294 356
295 357
296 358
297 359
298 360
299 361
300 362
301 363
302 364
303 365
304 366
305 367
306 368
307 369
308 370
309 371
310 372

Lead author last name et al. PNAS — May 22, 2023 — vol. XXX — no. XX — 3