KNX Type Multifuction Snsor
KNX Type Multifuction Snsor
Instructions d’installation
Installationsanweisungen
Instrucciones de instalación
Istruzioni per l’installazione
Installatie-instructies
インストール手順
DUS360CR 安装指示
Multifunction Sensor
Devices must be installed by a Los dispositivos deben ser instalados por un 装置を取り付ける際は、資格のある電気技師に依頼し、
electricista calificado y cumpliendo todas las 国および地域の電気および建設に関するすべての法令に
qualified electrician in accordance with normas y regulaciones, tanto nacionales como 従ってください。
all national and local electrical and locales, sobre instalaciones eléctricas y obras.
根据国家/地区及当地的电气与建筑规范和法规,该设
construction codes and regulations. I dispositivi devono essere installati da un 备必须由有资质的电工进行安装。
elettricista qualificato in conformità con le norme
Les appareils doivent être installés par un locali e nazionali vigenti in materia di costruzioni
électricien diplômé conformément à tous les .
edilizie e installazione di impianti elettrici.
codes et réglementations électriques et de
construction nationaux et locaux. De apparaten moeten worden aangebracht
Die Geräte sind von einem qualifizierten Elektriker door een gekwalificeerde elektricien en in
in Übereinstimmung mit allen geltenden overeenstemming met alle nationale en
Vorschriften zu installieren. plaatselijke elektriciteits- en bouwvoorschriften.
RJ12
72 mm (2.8 in)
63 mm (2.5 in)
DUS360CR
41 mm (1.6 in)
39 mm
(1.5 in)
1A PIR 1B 2 PIR .5
ft)
(6
m
>2
2.1 - 4.0 m (6.9 - 13.1 ft)
2.4 m (7.9 ft)*
*
ft)
120°
.7
(17
m
4
5.
0° C (32° F) www.lighting.philips.com/dynalite
3 PE 4 IR
60°
+12/24 V
D- ≤2A
D+
GND 64 mm
(2.5 in)
SHLD
+V
D-
D+
GND
SHLD
12/24 V 20 mA
IEC Overvoltage Category III
7 8 9
DyNet RS-485
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice – This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help. Any modifications not approved by the manufacturer of this device could void the user’s authority to operate this device.
This Class B digital apparatus complies with Canadian ICES-003: CAN ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la norme NMB-
003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply with HD 60364-4-41. The temperature limits and current-carrying capacities for
the communication wires specified in HD 384.5.523 shall not be exceeded.
Philips Dynalite
www.lighting.philips.com/dynalite
© 2017 Philips Lighting. All rights reserved.