Cambridge IGCSE: PHYSICS 0625/52

Download as pdf or txt
Download as pdf or txt
You are on page 1of 8

Cambridge IGCSE™

PHYSICS 0625/52
Paper 5 Practical Test October/November 2023

CONFIDENTIAL INSTRUCTIONS
* 7 3 5 3 2 0 3 5 8 8 *

This document gives details of how to prepare for and administer the practical exam.

The information in this document and the identity of any materials supplied by Cambridge International
are confidential and must NOT reach candidates either directly or indirectly.

The supervisor must complete the report at the end of this document and return it with the scripts.

INSTRUCTIONS
● If you have any queries regarding these confidential instructions, contact Cambridge International
stating the centre number, the syllabus and component number and the nature of the query.
email [email protected]
phone +44 1223 553554

This document has 8 pages.

DC (CJ/CB) 326595/1
© UCLES 2023 [Turn over
2

General information about practical exams

Centres must follow the guidance on science practical exams given in the Cambridge Handbook.

Safety

Supervisors must follow national and local regulations relating to safety and first aid.
Only those procedures described in the question paper should be attempted.
Supervisors must inform candidates that materials and apparatus used in the exam should be treated
with caution. Suitable eye protection should be used where necessary.
The following hazard codes are used in these confidential instructions, where relevant:
C corrosive MH moderate hazard
HH health hazard T acutely toxic
F flammable O oxidising
N hazardous to the aquatic environment
Hazard data sheets relating to substances used in this exam should be available from your chemical
supplier.

Before the exam

● The packets containing the question papers must not be opened before the exam.
● It is assumed that standard school laboratory facilities, as indicated in the Guide to Planning
Practical Science, will be available.
● Spare materials and apparatus for the tasks set must be available for candidates, if required.

During the exam

● It must be made clear to candidates at the start of the exam that they may request spare materials
and apparatus for the tasks set.
● Where specified, the supervisor must perform the experiments and record the results as instructed.
This must be done out of sight of the candidates, using the same materials and apparatus as the
candidates.
● Any assistance provided to candidates must be recorded in the supervisor’s report.
● If any materials or apparatus need to be replaced, for example, in the event of breakage or loss,
this must be recorded in the supervisor’s report.

After the exam

● The supervisor must complete a report for each practical session held and each laboratory used.
● Each packet of scripts returned to Cambridge International must contain the following items:
– the scripts of the candidates specified on the bar code label provided
– the supervisor’s results relevant to these candidates
– the supervisor’s reports relevant to these candidates
– seating plans for each practical session, referring to each candidate by candidate number
– the attendance register.

© UCLES 2023 0625/52/CI/O/N/23


3

Specific information for this practical exam

During the exam, the supervisor (NOT the invigilator) must do the experiment in Question 3
and record the results on a spare copy of the question paper, clearly labelled ‘supervisor’s
results’.

Question 1

Items to be supplied by the centre (per set of apparatus, unless otherwise specified)

(i) Clamp, boss and stand.

(ii) Pendulum bob attached to approximately 110 cm of inextensible string or thread. See note 1.

(iii) Metre ruler, graduated in mm.

(iv) Stop-watch or stop-clock with a minimum precision of 0.1 s.

(v) Split cork or similar device to hold the thread of the pendulum between the jaws of the clamp.
See note 2.

(vi) Set square.

Notes

1. The pendulum should be set up for the candidates with approximately 105 cm between the bottom
of the clamp supporting the thread and the centre of the bob.

2. Candidates must be able to easily adjust the length of the pendulum.

3. The pendulum must be able to swing freely. It may be necessary to increase the stability of the
clamp stand (for example, using a G-clamp or by placing a weight on the base).

Action at changeover

Arrange the pendulum as described in Note 1.

© UCLES 2023 0625/52/CI/O/N/23 [Turn over


4

Question 2

Items to be supplied by the centre (per set of apparatus, unless otherwise specified)

(i) Power supply of approximately 1.5–3 V. Where candidates are provided with a power supply
with a variable output voltage, the voltage must be set by the supervisor and fixed (e.g.
taped). See note 2.

(ii) Switch. The switch may be an integral part of the power supply.

(iii) Ammeter capable of reading up to 1.00 A with a resolution of at least 0.05 A. See note 3.

(iv) Voltmeter capable of measuring the supply p.d. with a resolution of at least 0.1 V. See note 3.

(v) Approximately 105 cm of straight, bare constantan (eureka) wire, diameter 0.28 mm (32 swg)
or similar resistance wire with resistance of approximately 8 Ω / m. The wire must be taped
to a metre ruler only between the 3 cm and 7 cm marks and between the 93 cm and 97 cm
marks. See note 4.

(vi) Two suitable terminals (e.g. crocodile clips) attached to the constantan wire at the ends of the
metre ruler so that connections can be made to the circuit shown in Fig. 2.1. The terminal at
the zero end of the ruler is to be labelled ‘B’. The terminal at the other end of the wire is to be
labelled ‘C’.

(vii) Sliding contact, labelled ‘S’. This may be a jockey or a small screwdriver connected to a lead
by means of a crocodile clip.

(viii) Sufficient connecting leads to set up the circuit shown in Fig. 2.1.

Notes

1. The circuit is to be set up for the candidates as shown in Fig. 2.1.

B C
sliding
contact S resistance wire
V

Fig. 2.1

© UCLES 2023 0625/52/CI/O/N/23


5

2. If cells are used, they must remain adequately charged throughout the examination. Spare cells
must be available.

3. Either analogue or digital meters are suitable. Any variable settings should be set by the supervisor
and fixed (e.g. taped). Spare meters must be available.

4. The wire must be attached to the metre ruler as shown in Fig. 2.2.

crocodile clip metre ruler crocodile clip

0 100

B tape tape C

Fig. 2.2

Action at changeover

Check that the circuit is arranged as shown in Fig. 2.1.

Check that the circuit works. Open the switch.

Question 3

Items to be supplied by the centre (per set of apparatus, unless otherwise specified)

(i) Thermometer, –10 °C to 110 °C, graduated in 1 °C intervals.

(ii) 250 cm3 beaker.

(iii) 250 cm3 measuring cylinder, graduated in 1 cm3 or 2 cm3 intervals.

(iv) Stop-watch or stop-clock or wall-mounted clock showing seconds.

(v) Clamp, stand and boss.

(vi) Supply of hot water. See notes 1 and 3.

(vii) Supply of paper towels to mop up any spills of water.

© UCLES 2023 0625/52/CI/O/N/23 [Turn over


6

Notes

1. The hot water is to be supplied for each candidate by the supervisor. The water should be
maintained at a temperature as hot as is reasonably and safely possible. Each candidate will
require about 300 cm3 of hot water.

2. The apparatus must be set up for the candidates as shown in Fig. 3.1.

thermometer

beaker
bench

Fig. 3.1

3. Candidates should be warned of the dangers of burns or scalds when using very hot water.

Action at changeover

Empty the beaker and measuring cylinder.

Dry the thermometer.

Check the supply of hot water.

Question 4

No apparatus is required for this question.

Permission to reproduce items where third-party owned material protected by copyright is included has been sought and cleared where possible. Every
reasonable effort has been made by the publisher (UCLES) to trace copyright holders, but if any items requiring clearance have unwittingly been included, the
publisher will be pleased to make amends at the earliest possible opportunity.

To avoid the issue of disclosure of answer-related information to candidates, all copyright acknowledgements are reproduced online in the Cambridge
Assessment International Education Copyright Acknowledgements Booklet. This is produced for each series of examinations and is freely available to download
at www.cambridgeinternational.org after the live examination series.

Cambridge Assessment International Education is part of Cambridge Assessment. Cambridge Assessment is the brand name of the University of Cambridge
Local Examinations Syndicate (UCLES), which is a department of the University of Cambridge.

© UCLES 2023 0625/52/CI/O/N/23


7

Supervisor’s report
Syllabus and component number /

Centre number

Centre name ............................................................................................................................................

Time of the practical session ...................................................................................................................

Laboratory name/number ........................................................................................................................

Give details of any difficulties experienced by the centre or by candidates (include the relevant
candidate names and candidate numbers).

You must include:


● any difficulties experienced by the centre in the preparation of materials
● any difficulties experienced by candidates, e.g. due to faulty materials or apparatus
● any specific assistance given to candidates.

© UCLES 2023 0625/52/CI/O/N/23 [Turn over


8

Declaration
1 Each packet that I am returning to Cambridge International contains all of the following items:
● the scripts of the candidates specified on the bar code label provided
● the supervisor’s results relevant to these candidates
● the supervisor’s reports relevant to these candidates
● seating plans for each practical session, referring to each candidate by candidate number
● the attendance register.
2 Where the practical exam has taken place in more than one practical session, I have clearly
labelled the supervisor’s results, supervisor’s reports and seating plans with the time and laboratory
name/number for each practical session.
3 I have included details of difficulties relating to each practical session experienced by the centre or
by candidates.
4 I have reported any other adverse circumstances affecting candidates, e.g. illness, bereavement or
temporary injury, directly to Cambridge International on a special consideration form.

Signed ................................................................................................................................. (supervisor)

Name (in block capitals) ..........................................................................................................................

© UCLES 2023 0625/52/CI/O/N/23

You might also like