Assignment 1
Assignment 1
Q.No.
1. Compute the phase velocity and wavelength in an FR4 printed circuit board whose relative
dielectric constant is 4.6 and where the operational frequency is 1.92 GHz.
2. The current flowing in a microstrip line (assumed to be infinite and lossless) is specified to be
i(t) = 0.6cos (9×109t-500z) A. Find the (a) phase velocity, (b) frequency, (c) wavelength, and (d)
phasor expression of the current.
3. A coaxial cable that is assumed lossless has a wavelength of the electric and magnetic fields of 2
= 20 cm at 960 MHz. Find the relative dielectric constant of the insulation.
4. The leads of a resistor in an RF circuit are treated as straight aluminium wires (σAl= 4.0 × 107
S/m) of AWG size 26 and of total length of 5 cm. (a) Compute the DC resistance. (b) Find the
AC resistance and inductance at 100 MHz, 1 GHz, and 10 GHz operating frequencies.
5. For the series RLC circuit with R = 1 Ω, L = 1 nH, and C = 1 pF, compute the resonance
frequency and quality factor at ±10% of the resonance frequency. Does the presence of the
resistor affect the resonance frequency?
6. Assuming that dielectric and conductor losses in a transmission line is small (i.e. G « C and R «
1 𝑅
ωL), show that propagation constant k can be written as k = α+ jβ = 2 (𝑍 + 𝐺𝑍𝑜 ) + 𝑗ω√𝐿 𝐶
𝑜
𝐿
where Zo = √𝐶 is the characteristic impedance of the line in the absence of loss.
7. Draw the block diagram of generic RF Systems and explain role each section briefly.
8. A signal generator is used to feed two loads, as shown in the following figure. Find the both the
power produced by the source and the power delivered to each load.