Scribd
Upload
118 views

Batelec Rta Guidelines

The document outlines BATELEC guidelines for equipment attached to their poles. It states that only 3 pieces of equipment are allowed directly on BATELEC poles: Network Access Points, Local Convergence Points/loop holders, and terminals/distribution points. Loop holders and local convergence points must be installed below the messenger wire at a maximum fiber optic cable loop of 20 meters. Fiber optic network access points should not have maintenance loops installed on Meralco poles. Local convergence points and loop holders count as one piece of equipment and should be installed directly on Meralco poles following the 3 equipment limit. Messenger wires and fiber optic cables must be installed below Meralco tubulars in designated right-of-way areas

Uploaded by

Daniel Bermodez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
118 views

Batelec Rta Guidelines

The document outlines BATELEC guidelines for equipment attached to their poles. It states that only 3 pieces of equipment are allowed directly on BATELEC poles: Network Access Points, Local Convergence Points/loop holders, and terminals/distribution points. Loop holders and local convergence points must be installed below the messenger wire at a maximum fiber optic cable loop of 20 meters. Fiber optic network access points should not have maintenance loops installed on Meralco poles. Local convergence points and loop holders count as one piece of equipment and should be installed directly on Meralco poles following the 3 equipment limit. Messenger wires and fiber optic cables must be installed below Meralco tubulars in designated right-of-way areas

Uploaded by

Daniel Bermodez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

BATELEC RTA

GUIDELINES
1. THREE EQUIPMENT ONLY ALLOWED BY BATELEC TO ATTACHED
DIRECTLY TO THEIR POLE.
EQUIPMENTS CONSIDER ARE THE FF:
• NAP “NETWORK ACCESS POIN” (PLDT, CONVERGE)
• LCP/ CLOSURE “LOCAL CONVERGENCE POINT”/LOOP HOLDER
• TERMINAL / DP “DISTRIBUTION POINT” this 2 are for copper cable

2. ONLY 1 LOOP HOLDER ALLOWED BY MERALCO ATTACHED TO THEIR


POLE.
• POSITION OF LOOP HOLDER AND LCP/CLOSURE
Loop Holder / LCP/Closure will be installed on the level of FH messenger wire or
under Messenger wire and installed in the field position.
• MAXIMUM LOOP OF FOC “Fiber Optic Cable”
20 meters
3. FH NAP INSTALLED IN MERALCO POLE SHOULD NO MAINTENANCE
LOOP.

4. LCP/CLOSURE AND LOOP HOLDER SHOULD INSTALLED DIRECTLY TO


MERALCO POLE, BUT FOLLOW THE 3 EQUIPMENT RULES. “Note:
LCP/CLOSURE AND LOOP HOLDER COUNT AS 1 EQUIPMENT.

5. IN INSTALLATION OF MESSENGER WIRE AND FOC IT SHOULD BE


UNDER THE MERALCO TUBULAR AND PUT IT ON THE DESIGNATED RTA
POSITION.

You might also like