Scribd
Upload
48 views2 pages

Lab. Activity No. 2 - EIGRP

This lab activity document outlines objectives and procedures for configuring the Enhanced Interior Gateway Protocol (EIGRP) in a network diagram. The objectives are to configure IP addresses, set up EIGRP routing in all networks shown in the diagram, and test connectivity. Materials needed include Packet Tracer software and the network diagram. Procedures include constructing the diagram, labeling devices, adding interfaces, configuring IP addresses, testing local connectivity, assigning classful addresses, testing connections between cities, and providing screenshots of output.

Uploaded by

secret
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
48 views2 pages

Lab. Activity No. 2 - EIGRP

This lab activity document outlines objectives and procedures for configuring the Enhanced Interior Gateway Protocol (EIGRP) in a network diagram. The objectives are to configure IP addresses, set up EIGRP routing in all networks shown in the diagram, and test connectivity. Materials needed include Packet Tracer software and the network diagram. Procedures include constructing the diagram, labeling devices, adding interfaces, configuring IP addresses, testing local connectivity, assigning classful addresses, testing connections between cities, and providing screenshots of output.

Uploaded by

secret
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Lab Activity No.

2
Enhanced Interior Gateway Protocol (BGP)
Yr./Sec. : ________ Course: ___________________________ Date Started : ______________

Grp. No. : ________ Date Finished : _____________


Percival D. Adao
Names :_______________________, _____________________, ____________________, ____________________

I. OBJECTIVES:
1. Configure IP address in all interfaces and terminals
2. Configure EIGRP in all the networks shown in figure 2
3. Test successful connection

II. MATERIALS:
1. Working PC
2. Cisco Simulator software
3. Lab. Activity No.2 data Sheet
4. Diagram/Figure 2

III. Procedures:
1. Using packet Tracer, construct the diagram in figure 2.
2. Label each device as shown in figure 2.
3. Add physical interfaces in each router if necessary
4. Identify the total number of networks in the diagram
5. Configure IP address in all interfaces from all networks
6. Test all of its local connectivity
7. Class A = group 6 & up
8. Class B = group 5 - 4
9. Class C = group 3 – 1
10.Test and verify connections using different terminals from dif. cities.
11.Provide screenshots of your output and replace and the given sample below.
a. Screenshots of successful connections from BGC to Ortigas
b. Screenshots of successful connections from Makati to Greenhill’s
c. Screenshots of successful connections from terminals 1-5, 2-6, 3-7 and 4-8
12. Save your work as your group number and activity number (ex. Grp3_Lab.Act2_EIGRP)
13. Submit this datasheet document in TBL hub together with the working PKT file with the same filename.

IV. Acquired Skills and Knowledge


(Answer this portion in line with the given objectives)

_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
____________________________________________________________________________________
SAMPLE OUTPUT:

You might also like