Scribd
Upload
130 views1 page

Practice Questions

This document discusses sinusoidal steady-state analysis of circuits containing capacitors and inductors. Some key points: - The impedance of a capacitor is 1/jωC and the impedance of an inductor is jωL. Impedances combine in the same way as resistances. - Analysis techniques used for resistive circuits can be applied to circuits with capacitors/inductors by replacing elements with their frequency-domain equivalents. - Phasor analysis can only be used for single-frequency circuits; superposition is needed for multiple frequencies.

Uploaded by

yoliswamavuso69
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
130 views1 page

Practice Questions

This document discusses sinusoidal steady-state analysis of circuits containing capacitors and inductors. Some key points: - The impedance of a capacitor is 1/jωC and the impedance of an inductor is jωL. Impedances combine in the same way as resistances. - Analysis techniques used for resistive circuits can be applied to circuits with capacitors/inductors by replacing elements with their frequency-domain equivalents. - Phasor analysis can only be used for single-frequency circuits; superposition is needed for multiple frequencies.

Uploaded by

yoliswamavuso69
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

410 CHAPTER 10 SINUSOIDAL STEADY-STATE ANALYSIS

• The impedance of a capacitor is 1/jωC .


• The impedance of an inductor is jωL .
❑ Impedances combine both in series and in parallel combinations in the
same manner as resistors. (Example 10.6)
❑ All analysis techniques previously used on resistive circuits apply to
circuits with capacitors and/or inductors once all elements are replaced
by their frequency-domain equivalents. (Examples 10.5, 10.7, 10.8,
10.9, 10.10, 10.11)
❑ Phasor analysis can only be performed on single-frequency circuits.
Otherwise, superposition must be invoked, and the time-domain partial
responses added to obtain the complete response. (Example 10.12)
❑ The power behind phasor diagrams is evident when a convenient forcing
function is used initially, and the final result scaled appropriately.
(Example 10.13)

READING FURTHER
A good reference to phasor-based analysis techniques can be found in:
R. A. DeCarlo and P. M. Lin, Linear Circuit Analysis, 2nd ed. New York:
Oxford University Press, 2001.
Frequency-dependent transistor models are discussed from a phasor perspec-
tive in Chap. 7 of:
W. H. Hayt, Jr., and G. W. Neudeck, Electronic Circuit Analysis and
Design, 2nd ed. New York: Wiley, 1995.

EXERCISES
10.1 Characteristics of Sinusoids
1. Evaluate the following: (a) 5 sin (5t − 9◦ ) at t = 0, 0.01, and 0.1 s; (b) 4 cos 2t
and 4 sin (2t + 90◦ ) at t = 0, 1, and 1.5 s; (c) 3.2 cos (6t + 15◦ ) and
3.2 sin (6t + 105◦ ) at t = 0, 0.01, and 0.1 s.
2. (a) Express each of the following as a single cosine function: 5 sin 300t,
1.95 sin (πt − 92◦ ), 2.7 sin (50t + 5◦ )  10 cos 50t. (b) Express each of
the following as a single sine function: 66 cos (9t − 10◦ ), 4.15 cos 10t,
10 cos (100t − 9◦ ) + 10 sin (100t + 19◦ ).
3. Determine the angle by which v1 leads i1 if v1 = 10 cos (10t − 45◦ ) and i1
is equal to (a) 5 cos 10t; (b) 5 cos (10t − 80◦ ); (c) 5 cos (10t − 40◦ );
(d) 5 cos (10t + 40◦ ); (e) 5 sin (10t − 19◦ ).
4. Determine the angle by which v1 lags i1 if v1 = 34 cos (10t + 125◦ ) and i1
is equal to (a) 5 cos 10t; (b) 5 cos (10t − 80◦ ); (c) 5 cos (10t − 40◦ );
(d) 5 cos (10t + 40◦ ); (e) 5 sin (10t − 19◦ ).
5. Determine which waveform in each of the following pairs is lagging: (a) cos 4t,
sin 4t; (b) cos (4t − 80◦ ), cos (4t); (c) cos (4t + 80◦ ), cos 4t; (d) −sin 5t, cos
(5t + 2◦ ); (e) sin 5t + cos 5t, cos (5t − 45◦ ).
6. Calculate the first three instants in time (t > 0) for which the following
functions are zero, by first converting to a single sinusoid: (a) cos 3t − 7 sin 3t;
(b) cos (10t + 45◦ ); (c) cos 5t− sin 5t; (d) cos 2t + sin 2t− cos 5t + sin 5t.
7. (a) Determine the first two instants in time (t > 0) for which each of the
functions in Exercise 6 are equal to unity, by first converting to a single
sinusoid. (b) Verify your answers by plotting each waveform using an
appropriate software package.

You might also like