Scribd
Upload
49 views1 page

... The L-Series PWM Input Looks Like... For This Type of PWM Source..

The document describes different types of PWM input sources that are compatible with the L-Series position controller. It shows that the L-Series can be configured for pull-down, pull-up, or push-pull PWM inputs. For each input type, it provides a circuit diagram showing how the signal would connect to pin 11 on the L-Series and be processed, either by comparing the clamped signal to a 2.5V reference or passing it directly to the processor.

Uploaded by

pukimac.x
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views1 page

... The L-Series PWM Input Looks Like... For This Type of PWM Source..

The document describes different types of PWM input sources that are compatible with the L-Series position controller. It shows that the L-Series can be configured for pull-down, pull-up, or push-pull PWM inputs. For each input type, it provides a circuit diagram showing how the signal would connect to pin 11 on the L-Series and be processed, either by comparing the clamped signal to a 2.5V reference or passing it directly to the processor.

Uploaded by

pukimac.x
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

L-Series Position Controller w/ CAN Capability Manual 26635

For this type of PWM Source... ...the L-Series PWM Input looks like...

High-Side Open-Collector (open-drain) PWM Source L-Series Configured for “Pull-Down”

5 - 32 VDC

L-Series
Pin 11
To
PNP (or P-Channel FET) 4 kW 9.5 kW Processor
Internal Clamped to 5V, then
12 kW
Command compared with 2.5V reference.

L-Series Configured for “Pull-Up”


Low-Side Open-Collector (open-drain) PWM Source
Internal 5V
Pull-Up

L-Series 12 kW
NPN (or N-Channel FET) Pin 11
To
Internal 4 kW 9.5 kW Processor
Command
Compared with 2.5V
reference.

Push-Pull PWM Source (three kinds)

5 - 32 VDC L-Series Configured for “Push-Pull”

L-Series
Pin 11
To
Internal 5 - 32 VDC
Processor
Command OR 13.5 kW

Clamped to 5V, then


compared with 2.5V reference.

Internal
Command
5 - 32 VDC
OR

Internal
Command

Figure 3-5. Acceptable PWM Input Types

38 Woodward

You might also like