FS-TABLE compatible with

your entire board game collection!

Assembly Instructions FS-TABLE
The package contains ten sheets: four double sheets and two single sheets.
After assembly optional LED strips can be installed to illuminate the playing area.
Ordinary PVA glue is required when assembling each stage.
Please make sure you dry-assemble each stage correctly before gluing it together.
Please check www.foldedspace.com for general assembly tips.
We recommend building the table in four stages, waiting in between for the
glue to dry before combining the sub-assemblies.

Sheet A1, A2 Sheet B1, B2 Sheet C1, C2 Sheet D1, D2 Sheet E Sheet F
Transformer
hole

Stage A — Tabletop
Sheet A1, A2 Sheet B1, B2 Base Step 1 Step 2

Sheet C1, C2 Sheet D1, D2 Side walls Step 3 Wall with gaps for LED light cables
must be placed at same end as the Step 4
hole for the transformer

Wall top
Step 5
Sheet E Sheet F Finished tabletop
Transformer
Step 6
hole
LED light cable gaps

Stage B — Legs Dice Tower Legs

Sheet A1, A2 Sheet B1, B2 Step 1 Step 2 Step 3 Step 4 Finished legs
2x

2x
Normal Legs
Sheet C1, C2 Dice trays Step 1 Step 2 Step 3

Step 1 Step 2 Finished

tray

x2

Page 1 of 2
FS-TABLE compatible with
your entire board game collection!
Stage C — Tabletop Brace
Sheet D1, D2 Sheet E

Stage D — Fittings Dice

Sheet C1, C2
Tower

Dice
Tower

Gap
Stage E — Dice Assembly
Sheet D1, D2
Gap
Step 1 Step 2 Step 3 Finished
die

x2

FS-TABLE
Please check www.foldedspace.com
Dice Tower for photos of this insert in use.

Dice Assembly Guide

Stage A: build the table surface and side walls. In all stages
apply glue to all surfaces in contact with other pieces. Ensure
that the glue is fully dry before moving on to Stage C.

Stage B: the legs can be assembled while the table surface is

drying. Note that there are two of each of the two types of
legs, so you should have two legs containing dice towers and
two normal legs.

Stage C: once the table surface from Stage A is fully dry turn it
upside-down and add the middle brace pieces to the under-
side. You can then proceed straight to Stage D.

Stage D: add the legs using the small connector pieces. Once
Brace for bottom surface fully assembled leave the table upside-down over night to
allow the glue to fully dry.
Cup Holders
Note: a separate LED light strip set can be added after the
Dice Tower table is fully assembled. The LED tape strip can be applied to
the underside of the inside lip on the upper arm rest walls.
Use the holes at one end of the table to pass the cabling
through to the transformer which can be stored inside the
side wall.

Tip: Keep the instructions in the hollow part of the table as a reminder of how it ts together. Page 2 of 2