0% found this document useful (0 votes)
24 views4 pages

Experiment 11

This document provides instructions for an experiment involving an 8-bit analog to digital converter (ADC 0809) and an 8-bit digital to analog converter (DAC 0808). The objectives are to design circuits for each chip and study their operation. For the ADC, students apply analog input voltages, read the digital outputs, and calculate errors. They also examine the ADC timing diagram and datasheet. For the DAC, the digital outputs of the ADC are connected to the DAC inputs to reconstruct the original analog voltages at the DAC output for comparison. Circuit diagrams are provided.

Uploaded by

Riya Koreti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
24 views4 pages

Experiment 11

This document provides instructions for an experiment involving an 8-bit analog to digital converter (ADC 0809) and an 8-bit digital to analog converter (DAC 0808). The objectives are to design circuits for each chip and study their operation. For the ADC, students apply analog input voltages, read the digital outputs, and calculate errors. They also examine the ADC timing diagram and datasheet. For the DAC, the digital outputs of the ADC are connected to the DAC inputs to reconstruct the original analog voltages at the DAC output for comparison. Circuit diagrams are provided.

Uploaded by

Riya Koreti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Measurements & Electronic Instruments

Laboratory Experiment Manual


Department of Electrical Engineering, I.I.T. Kharagpur
Experiment No. : 11

ANALOG TO DIGITAL CONVERTER AND VICE-VERSA


Objective:
a) To design and develop an 8-bit Analog to Digital converter circuitry
based on IC ADC-0809.
b) To design and develop an 8-bit Digital to Analog converter circuitry
based on IC DAC-0808.
PART A: STUDY OF ADC 0809
Instruction:
i) IN 0 to IN 7: Analog
input channels.
ii) 2-1 to 2-8 Digital
output pins.
iii) ADD A, ADD B &
ADD C – Address lines
(for input channel
selection).
iv) ALE: Address Latch
Enable.
v) START: Input pin for
starting the Analog to
Digital conversion.
vi) EOC: End of
Conversion.
Procedure:
1) Connect the circuit as shown in Fig-2.
2) Select an input channel (say channel 0) and give input to the address
lines (AD0 – AD2) as required (SEE Fig-3).
3) Apply different input voltages to the input channel selected and
measure the digital output through LED’S.
4) Compute the error between detected Output & applied Input voltage.
(1)
5) Choose another channel and repeat steps 2 & 3.

Report:

(2)
Discuss the basic principle of operation of ADC 0809 following the ‘TIMING
DIAGRAM” shown in Fig - 4. For further clarification look into the datasheet
of the IC.

PART B: STUDY OF DAC 0808


Procedure:
1) Without disturbing
the circuit in Fig- 2,
connect the DAC circuit as
shown in Fig – 6.
2) Connect the output
terminals of ADC 0809 to
the input terminals (DB0 –
DB7) of ADC 0808.
3) Now one should get
the same analog voltage
applied to ADC 0809 at the
output of DAC 0808.
Compare the same for
different input voltages.

CIRCUIT DIAGRAM :

(3)
(4)

You might also like