Technical Data Sheet

NATIONAL SYNTHETIC ENAMEL GLOSS I

DESCRIPTION TYPICAL PROPERTIES
A general purpose economical synthetic enamel As per National
Color Dry film
Shade card
based on alkyd resin for architectural paint.
Finish Dry film Smooth/Matt

Specific Gravity 1.09 ± 0.05

Volume Solids (ASTM D2697) 43 ± 2%

Theoretical Spreading rate 11-14
RECOMMENDED USES ( TSR ) m2 / liter
• Wood, Masonry, Steel and other surfaces Dry film thickness ( DFT )
30-40
• Moderate environments microns / coat
70-95
Wet film thickness ( WFT)
microns / coat

Flash Point 38°C

ADVANTAGES PACKAGING SIZE

• High gloss • 0.90 liters
• Good resistance to abrasion • 3.6 liters
• Good washability • 18 liters
• Very good adhesion
• Very good hiding power

CERTIFICATIONS DRYING TIME

• Certificates are available upon request Overcoating
Surface
Hard dry interval with
Temp. dry
(Hours) recommended
(Hours)
top coats
Min max
(Hours)
10⁰C 30 48 48 Ext.
20⁰C 16 32 32 Ext.

30⁰C 8 24 24 Ext.

40⁰C 6 20 20 Ext.

This data sheet supersedes all previous issued.

ISO 9001, 14001 & 45001 Issued: 0622
CERTIFIED FACTORY
www.nationalpaints.com Page 1 of 2
 Technical Data Sheet

SURFACE PREPARATION SAFETY PRECAUTIONS

It can be applied directly as topcoat over suitably • Avoid skin and eye contact by wearing overalls,
prepared primer or undercoat surface. gloves, goggles, and mask etc.
• Eyes: In the event of accidental splashes, flush
eye with water immediately and obtain medical
advice.
APPLICATION METHOD
• Skin: Wash skin thoroughly with soap and water
Thinner National GP Thinner or approved industrial cleaner.
• Avoid inhalation of vapours and paint mist by
Tip Range:0.018” – 0.020” wearing suitable mask. In the event of ingestion
Airless spray Pressure: 2000-2200 psi seek medical attention immediately.
Thinner addition: 5-15% • This product is flammable, keep away from
sources of ignition. Take precautionary measures
Conventional Atomizing pressure: 50 psi against static discharge. In the case of fire –
spray Thinner addition: 5-15% blanket flames with foam, carbon dioxide or dry
chemicals.
Brush, Roller Thinner addition:5 – 15 % • Painting must be carried out in well-ventilated
area. Local safety regulations need to be
followed
RECOMMENDED SYSTEM STORAGE & SHELF LIFE
• Store the paint in proper storage conditions as
National Red Oxide Primer 40 microns
per the local regulations. Keep the paint
National Synthetic container in sealed condition under shed, away
40 microns
Undercoat from direct sunlight and extreme temperatures.
National Synthetic Enamel • Do not keep paint material near to any ignition
80 microns sources.
Gloss I
• Do not put back the half or unused material
• Please consult National Technical team for back in original container, containing the
other system recommendation. supplied paint, to avoid contamination.
• Handle with care.
• Stir well before use.
• Shelf life at 30°C is 18 months in original sealed
container, with proper storage conditions.

NOTE: We warranty only the quality of our product and this data sheet is based on results obtained from experience and tests. We
reserve the right to change data without prior notice. For safety details kindly refer safety data sheet.
This data sheet supersedes all previous issued.
ISO 9001, 14001 & 45001 Issued: 0622
CERTIFIED FACTORY
www.nationalpaints.com Page 2 of 2