Scribd
Upload
1K views2 pages

Distribution Panel Board Testing Checklist

The document is a checklist for testing and commissioning a control panel or distribution board. It lists various items to check, including verifying documentation and drawings are available, inspecting for damage, checking labeling and identification of live components, ensuring proper earthing, testing insulation resistance and voltage, and performing operational tests of circuit breakers, ELCBs, and RCCBs. The checklist is to be signed off by the technician, site in-charge, engineer, and electrical inspector.

Uploaded by

Sumit Saurabh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
1K views2 pages

Distribution Panel Board Testing Checklist

The document is a checklist for testing and commissioning a control panel or distribution board. It lists various items to check, including verifying documentation and drawings are available, inspecting for damage, checking labeling and identification of live components, ensuring proper earthing, testing insulation resistance and voltage, and performing operational tests of circuit breakers, ELCBs, and RCCBs. The checklist is to be signed off by the technician, site in-charge, engineer, and electrical inspector.

Uploaded by

Sumit Saurabh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Distribution Panel Board Testing & Commissioning Checklist

Report on Testing and Commissioning


CONTROL PANEL / DISTRIBUTION BOARD

Found Not
S.No Description Activity N/A
Satisfied Satisfied

Drawing-SLD and DB Scheduling must be kept in


1
the DB Pocket. General/Document
Verification
2 Certificate of Calibration for Testing Equipment.

3 There is no evident damage to compromise safety.


Ensure that the testing & commissioning are
4
performed with approved MS and MAS.

5 Appropriate Tagging & Labelling

Screening all live components with an earthed metal


6
or an insulating plate.
On the distribution board, phase identification is
7
provided.
Visual Analysis
8 Effective earthing of all exposed metal components.

Effectively earthed are all metal conduits, switch


9
boxes, trunking, and exposed metal components.
Steel conduit or trunking should be used to protect
all wires that aren't armoured against damage. If
10
necessary, bushing and a rubber grommet are
provided.
The size of the conductor must correspond to the
11
MCB or FUSE that is protect the circuit.
All metal conduit or trunking junctions must be
12 structurally strong, electrically continuous, and
corrosion-resistant.

13 Effective earthing of all exposed conductors.

14 Earthing of the panel door must be done.


Check each connection's tightness, and clean each
15
supporting insulator.
16 Tagging of the incoming DB cable must be done.

17 Insulation resistance between the phases, neutral,


and earth of at least 0.5 M ohm.
18 Voltage monitoring on the O/G Power Circuit Testing &
Commissioning
19 Phase sequence checking
On/Off & manual trip test checks for MCCB's &
120
MCB's
21 Checking ELCB, RCCB, and RCD

Report:
1.
2.
3.
4.
5.

Electrical
Technician Site Incharge Engineer
Inspector

NAME

SIGNATURE

SEAL

DATE

You might also like