Scribd
Upload
36 views4 pages

2022

Uploaded by

華宏霖 HUA,HONG-LIN E34106191
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
36 views4 pages

2022

Uploaded by

華宏霖 HUA,HONG-LIN E34106191
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 4
causes oscillation in the response to a setpoint change. py tt eee) keel Soe Y = Yq CIO” Boge eld *¥eL ye) we) Selecting a large c (@) Always true (b) Sometimes true (©) False (@ Sometimes false 2. A product ecnceniration control system fora chemical reactor is shown below. (@) Draw and label a block diagram of a feedback control system for this process, dynamics ofthe analyzer/transmitter, PD controller, and valve. (10%) ° (b) Consider the case when the analyzer/transmitter’s transfer functi transfer function Gy(s) = 1, and the process transfer Funct eae ic al area a (f@), is feeding material (with density p in tank shown below, with cross section: ‘contain A component. {to Process 1 and Process 2. Note that Stream 2 does not wy Cult) watt) Ct) { nt) xo To Process 2 eo "aan f To Process 1 where w [=] Ibmv/min; Ca [=] Ibm A/f; R [=] min/f?; h [=] ft w1 and R are constants (a) Determine the dynamic model for the above process using the variables given. (Hint: the flow rate ofthe feed to Process 2 = 2M) (10%) (0) A.ctitical condition for safe operation isnot to have overflow from materials féeding Process T. Based on this objective, what action do you recommend for the control valve for the process above andwhy? (5%) (c) As an engineer, you recommended that level for the above tank be controlled by an automatic feedback loop. As usual you got the assignment to install the system. You purchased the following leaving the blocks. (25%) transfer function between a temperature T (°C) and an nts have units of minutes: Ts) _ 31-5) Qs) s2s+1) 3s sinusoidally with an amplitude of 2 L/min and a period of 0.5 min, find the e angle of the temperature signal after the transients have died out?

You might also like