Scribd
Upload
21 views3 pages

05-Interface Range Configuration

The document discusses interface range configuration, which allows configuring the same attributes on multiple ports of the same type to reduce workload. It describes entering interface range mode using a command specifying slot number and port ranges separated by hyphens and commas. An example enters interface range mode for ports fe1-3, 6, 8, and 10-12 on slot 0.

Uploaded by

jon jonsons
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
21 views3 pages

05-Interface Range Configuration

The document discusses interface range configuration, which allows configuring the same attributes on multiple ports of the same type to reduce workload. It describes entering interface range mode using a command specifying slot number and port ranges separated by hyphens and commas. An example enters interface range mode for ports fe1-3, 6, 8, and 10-12 on slot 0.

Uploaded by

jon jonsons
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Interface Range Configuration

Table of Contents

Table of Contents
Chapter 1 Interface Range Configuration........................................................................................... 1
1.1 Interface Range Configuration Task ..................................................................................... 1
1.1.1 Understanding Interface Range ................................................................................. 1
1.1.2 Entering Interface Range Mode ................................................................................. 1
1.1.3 Configuration Example............................................................................................... 1

-I-
Interface Range Configuration

Chapter 1 Interface Range Configuration

1.1 Interface Range Configuration Task

1.1.1 Understanding Interface Range

In the process of configuring interface tasks, there are cases when you have to
configure the same attribute on ports of the same type. In order to avoid repeated
configuration on each port, we provide the interface range configuration mode.
You can configure ports of the same type and slot number with the same
configuration parameters. This reduces the workload.

Note:

when entering the interface range mode, all interfaces included in this mode
must have been established.

1.1.2 Entering Interface Range Mode

Run the following command to enter the interface range mode.

Step Command Description


1 interface range type slot/<port1 - port2 | Enters the range mode. All ports included in this
port3>[ , <port1 - port2|port3>] mode accord to the following conditions:

(1) The slot number is set to slot.

(2) The port numbers before/after the hyphen must


range between port1 and port2, or equal to
port3.

(3) Port 2 must be less than port 1

(4) There must be space before/after the hyphen or


the comma.

1.1.3 Configuration Example

Enter the interface configuration mode via the following commands, including slot 0 and
fast Ethernet 1,2,3,6,8,10,11,12:
switch_config#interface range 1 - 3 , 6 , 8 , 10 - 12
switch_config_if_range#

-1-

You might also like