Scribd
Upload
45 views10 pages

Ch1-5 Energy Methods

This document provides examples of using modeling and energy methods to derive equations of motion (EOM) for mechanical systems. The key concepts covered are: - For conservative systems, the total energy (kinetic + potential energy) is constant. - At maximum displacement, potential energy is maximum and kinetic energy is 0. At equilibrium, potential energy is 0 and kinetic energy is maximum. - Examples are provided to derive EOM for springs, masses on springs, rotating shafts/pedals, and multi-degree of freedom systems using energy methods and Lagrange's equations.

Uploaded by

manat_swu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views10 pages

Ch1-5 Energy Methods

This document provides examples of using modeling and energy methods to derive equations of motion (EOM) for mechanical systems. The key concepts covered are: - For conservative systems, the total energy (kinetic + potential energy) is constant. - At maximum displacement, potential energy is maximum and kinetic energy is 0. At equilibrium, potential energy is 0 and kinetic energy is maximum. - Examples are provided to derive EOM for springs, masses on springs, rotating shafts/pedals, and multi-degree of freedom systems using energy methods and Lagrange's equations.

Uploaded by

manat_swu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

Modeling and energy methods (1)

In the conservative system (free vibration, undamped system),


the total energy is constant.

Sum of kinetic and potential energy = constant

T + U = constant
1 m T1 + U 1 = T2 + U 2
m
m
Equilibrium 2
where
position 3
T is kinetic energy
U is potential energy
Modeling and energy methods (2)

T + U = constant
1 m
m T1 + U 1 = T2 + U 2
m
Equilibrium 2
position 3
At max disp. U = U max T =0
At equilibrium U =0 T = Tmax

Let 1 = position at max disp., 2 = position at equilibrium

U max + 0 = 0 +T max U max =T max


Example (1)
1
U Spring = k (Δ + x) 2
2
Unstretched U Grav = − mgx
Equilibrium Δ Ref.
m x 1 2
T = mx&
2
[T + U = const.] 1 2 1
mx − mgx + k (Δ + x ) 2 = const .
&
2 2
Differentiating mx&&x& − mgx& + k ( Δ + x ) x& = 0

(m&x& − mg + kΔ + kx) x& = 0

mg = kΔ (Equilibrium cond.)
m&x& + kx = 0
x& ≠ 0 (In general cases)
Example (2)
Model the mass of the spring of the system shown in the figure.
Derive EOM including the effect of the mass of the spring.

ms, k
Example (3)
Derive the EOM of an airplane’s steering-gear mechanism for
the nose wheel of its landing gear. The mechanism is modeled
as the single-degree-of-freedom system illustrated in the figure.
[Inman/1.49]
Example (4)
A control pedal of an aircraft can be modeled as the single-
degree-of-freedom system shown in the figure. Consider the
level as a massless shaft and the pedal as a lumped mass at
the end of the shaft. Determine the EOM in θ. Assume the
spring to be unstretched at θ = 0. [Inman/1.50]

θ
Example (5)
To save space, two large pipes are shipped one stacked inside
the other as indicated in the figure. Derive the EOM of the
smaller pipe (of radius R1) rolling back and forth inside the
large pipe (of radius R). Use the energy method and assume
that the inside pipe rolls with out slipping and has a mass of m.
[Inman/1.51]

θ
Example (6)
Consider the disk of the figure connected to two springs.
Derive EOM for small angle θ (t). [Inman/1.82]

θ (t)
Energy method for multi-DOF
Eom of the multi-DOF can be derived using Lagrange’s
equations as follow.
Lagrange’s equations

d ⎛ ∂T ⎞ ∂T ∂U i = 1,2, K , n
⎜⎜ ⎟⎟ − + = Qi
dt ⎝ ∂q&i ⎠ ∂qi ∂qi coordinate i,
(according to DOF)

Where qi is the generalized coordinate


q&i is the generalized velocity
Qi is the nonconservative forces corresponding to qi

Force for qi = translation coordinate


Moment for qi = rotation coordinate
Example (Lagrange’s equations)
Derive the EOM of the system shown in the figure using the
lagrange’s equations.

You might also like