The document contains G-code instructions for tool paths involving tool 1 with a diameter of 3 units. It describes moving the tool to various x,y,z coordinate positions using line segments with feed rates ranging from 300 to 1000 units/minute to cut multiple contours around 0.2, 0.4, 0.6, 1.2, and 1.4 units deep at two separate locations. The g-code routines cut the contours in a repeating pattern getting progressively deeper after each pass.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
0 ratings0% found this document useful (0 votes)
41 views27 pages
1 NC
The document contains G-code instructions for tool paths involving tool 1 with a diameter of 3 units. It describes moving the tool to various x,y,z coordinate positions using line segments with feed rates ranging from 300 to 1000 units/minute to cut multiple contours around 0.2, 0.4, 0.6, 1.2, and 1.4 units deep at two separate locations. The g-code routines cut the contours in a repeating pattern getting progressively deeper after each pass.