2

1 Fig. 1.1 shows the speed–time graph for a car travelling on a straight horizontal road.

20
speed
m/s

10

0
0 10 20 30 40 50
time / s

Fig. 1.1

(a) Describe the motion of the car shown in Fig. 1.1.

...................................................................................................................................................

...................................................................................................................................................

...................................................................................................................................................

............................................................................................................................................. [2]

(b) At time t = 10 s the engine of the car is switched off. The brakes are not applied.

(i) Name two forces that act on the car to cause the change in motion after t = 10 s.

1 ........................................................................................................................................

2 ........................................................................................................................................
[1]

(ii) Suggest why Fig. 1.1 is a curve after t = 10 s.

...........................................................................................................................................

...........................................................................................................................................

................................................................................................................................... [1]

© UCLES 2023 5054/22/M/J/23

(c) Between t = 10 s and t = 20 s the speed of the car changes from 18 m / s to 11 m / s.

The mass of the car is 1200 kg.

(i) Calculate the change in momentum of the car in this time.

Give the unit of your answer

momentum change = ...................................... unit ........... [2]

(ii) Calculate the average resultant force exerted on the car during this time.

average resultant force = ..................................................... N [2]

[Total: 8]

© UCLES 2023 5054/22/M/J/23 [Turn over

(c) The battery is marked ‘energy capacity 0.35 kilowatt-hour (kW h)’.

(i) Define what is meant by a kilowatt-hour.

...........................................................................................................................................

..................................................................................................................................... [1]

(ii) The scooter stops working because the battery is totally discharged (flat). This means
that there is no more energy stored in the battery.

The battery is then recharged using a 70 W power supply.

Calculate the time taken to fully recharge the battery.

time = ............................................... hours [2]

[Total: 8]

© UCLES 2023 5054/22/M/J/23 [Turn over

6 Fig. 6.1 shows an electric circuit containing a filament lamp, a resistor R, a 12 V battery and five
meters.

12 V

ammeter ammeter
A A
A1 A3
ammeter
A2
resistor R
A

V V
voltmeter voltmeter
V1 V2

Fig. 6.1

(a) (i) The reading on ammeter A1 is 0.25 A.

The reading on voltmeter V1 is 3.0 V.

Determine the readings on the other meters.

reading on ammeter A2 = ............................................................ A

reading on ammeter A3 = ............................................................ A

reading on voltmeter V2 = ........................................................... V

(ii) Calculate the resistance of resistor R.

resistance of resistor R = ..................................................... Ω [2]

© UCLES 2023 5054/22/M/J/23

(iii) The resistor obeys Ohm’s law.

State Ohm’s law.

...........................................................................................................................................

...........................................................................................................................................

..................................................................................................................................... [2]

(b) Fig. 6.2 shows the current–voltage graph for the filament lamp.

0.40

0.30

current / A

0.20

0.10

0
0 2 4 6 8 10 12
voltage / V

Fig. 6.2

The battery in Fig. 6.1 is replaced with a different battery which has a different e.m.f.
(electromotive force).

The voltage across the lamp increases to 6.0 V.

Use data from the graph to determine the e.m.f. of the second battery.

Show your working.

e.m.f. = ...................................................... V [3]

[Total: 9]
© UCLES 2023 5054/22/M/J/23 [Turn over