Scribd
Upload
24 views4 pages

Report Exp.6

The document is an experiment report on capacitors and inductors. The aim was to find the time constant in RC, RL, and LC circuits. For the RC circuit, the experimental time constant was 120 msec and theoretical was 100 msec. For the RL circuit, the experimental time constant was 7.4 msec and theoretical was 10 msec. For the LC circuit, the experimental frequency was 4.6 KHz and theoretical was 5.032 KHz. The report includes the theory behind how RC, RL, and LC circuits work and the equations used.

Uploaded by

عبدالرحمن عطاري
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
24 views4 pages

Report Exp.6

The document is an experiment report on capacitors and inductors. The aim was to find the time constant in RC, RL, and LC circuits. For the RC circuit, the experimental time constant was 120 msec and theoretical was 100 msec. For the RL circuit, the experimental time constant was 7.4 msec and theoretical was 10 msec. For the LC circuit, the experimental frequency was 4.6 KHz and theoretical was 5.032 KHz. The report includes the theory behind how RC, RL, and LC circuits work and the equations used.

Uploaded by

عبدالرحمن عطاري
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Physics Department

Physics 112
Experiment no.6 Report

Experiment Name:
Capacitors and Inductors

Student Name: Abedulrahman Attari.


Student NO: 1191908.
Partner Name: Abdulghafer Qeel.
Partner No: 1210400.
Partner Name: Saad Forhal.
Partner No: 1203220.

Section: - 7
Date: 7/12/2022
Instructor: Hana' Bashir.
Abstract:
The aim of the experiment: is to find out the time constant
in RC, RL, and LC circuits.

The method used: is by using the DCO to measure the


voltage in the RC and RL circuits and to measure the frequency
in the LC circuit.

Apparatus: Resistor (one k-ohm), Inductor (10 mH), Capacitor


(1μF), and an Osilloscope.

The main result:

RC_Circuit:
τ (exp) = 120 m(sec)
τ (theo) = 10x10*-3 (sec)

LR_Circuit:
τ (exp) = 7.4 m(sec)
τ (theo) = 10x10*-6 (sec)

LC_Circuit:
f (exp) = 4.6 KH
W (exp) = 28.9 K

f (theo) = 5.032 KH
W (theo) = 31.6 KH
Theory:
RC circuits:
Charging a capacitor:
The voltage across the capacitor’s plates is defined by

and while

(When we are talking about the positive half period of the square wave)
then

The value of RC is usually called the time constant (τ) of the RC circuit.
τ is a measure of how fast the voltage across the capacitor rises. When
, .
The current passing through the circuit is given by:

,
and while the voltage across the resistor is

Discharging a capacitor:
During the negative period of the square wave, the capacitor, the
capacitor discharges according to the following formula:

Therefore, the voltage across the capacitor’s plates is:

The voltage decays to 0.37 of its maximum value within a time τ, which
equals RC (the time constant).
The current passing through the circuit is

and so, the voltage is given by:


RL circuits:
The current passing through the RL circuit is with time according to the
following equation:

The voltage across the resistor is

and across the inductor is

.
In this case, the time constant equals L/R When ,

and .

LC circuits:
The following equation describes the voltage across the capacitor’s
plates of the one in the circuit.

Where is the amplitude (constant) and

You might also like