Scribd
Upload
434 views2 pages

Pass Partition Calculation

The document contains calculations to determine the minimum required thickness of pass partition plates for two items. For the front item, a thickness of 20 mm was calculated based on the design data and equations in TEMA standards. For the rear item, a thickness of 18.32 mm was calculated, but a 20 mm nominal thickness will be used.

Uploaded by

jambhatti75
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
434 views2 pages

Pass Partition Calculation

The document contains calculations to determine the minimum required thickness of pass partition plates for two items. For the front item, a thickness of 20 mm was calculated based on the design data and equations in TEMA standards. For the rear item, a thickness of 18.32 mm was calculated, but a 20 mm nominal thickness will be used.

Uploaded by

jambhatti75
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 2

PASS PARTITION PLATE THICKNESS CALCULATION as per TEMA RCB-9.

132
Item # D69-E-0058ABC (FRONT)
DESIGN DATA:

Material of Pass Partition Plate = SA 516 Gr.70


Pressure Drop Across Plate q = 68.95 kPa
Design Temperature DT = 148.9 °C
Allowable Stress in tension at Design Temperature S = 138000 kPa
Width of Pass Partition Plate a = 1288.4 mm
Length of Pass Partition Plate b = 1143 mm
Corrosion Allowance C.A = 6.4 mm RCB-1.518
Pass Partion Plate Type Type = 2-Sides Fixed

Ratio a/b = 1.13


Table Value B = 0.425 Table RCB9-9.132

Minimum Required Thickness of Pass Partition Plate t1 = RCB-9.132

= 20.00 mm
Minimum Required Thickness of Pass Partition Plate t2 = 12.7 mm Table RCB9-9.131

Required Thickness (the greater of t 1 or t2) t = 20.00 mm

Used Nominal Pass Partition Plate Thickness T = 16 mm


PASS PARTITION PLATE THICKNESS CALCULATION as per TEMA RCB-9.132
Item # D69-E-0058ABC (REAR)
DESIGN DATA:

Material of Pass Partition Plate = SA 516 Gr.70


Pressure Drop Across Plate q = 51.7107 kPa
Design Temperature DT = 215.556 °C
Allowable Stress in tension at Design Temperature S = 138000 kPa
Width of Pass Partition Plate a = 5264.2 mm
Length of Pass Partition Plate b = 1066.8 mm
Corrosion Allowance C.A = 6.4 mm RCB-1.518
Pass Partion Plate Type Type = 2-Sides Fixed

Ratio a/b = 4.93


Table Value B = 0.5 Table RCB9-9.132

Minimum Required Thickness of Pass Partition Plate t1 = RCB-9.132

= 18.32 mm
Minimum Required Thickness of Pass Partition Plate t2 = 12.7 mm Table RCB9-9.131

Required Thickness (the greater of t 1 or t2) t = 18.32 mm

Used Nominal Pass Partition Plate Thickness T = 20 mm

You might also like