Scribd
Upload
19 views3 pages

Lab Terminal Exam

This document contains instructions for a computer networks exam. It includes 5 questions about configuring access control lists on routers to restrict network access between subnets. It also includes a question about basic router configuration, IP addressing, and static routing verification between routers and PCs.

Uploaded by

Ahmad Ghani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
19 views3 pages

Lab Terminal Exam

This document contains instructions for a computer networks exam. It includes 5 questions about configuring access control lists on routers to restrict network access between subnets. It also includes a question about basic router configuration, IP addressing, and static routing verification between routers and PCs.

Uploaded by

Ahmad Ghani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Course Title: Data Communication & Course Code: CSC 339 Credit Hours: 2+1

COMSATS University Islamabad


Computer Networs
Course Instructor: Ms. Wajiha Farooq SahiwalProgramme
Campus BSCS
(Department of Computer
Name: Sciences)
th
Semester: 6 Batch: SP-21 Section: A,B Date: 26-12-2023
Time Allowed: 3 hours Maximum Marks: 50
Student’s Name: Reg. No. CUI/
/SWL
Important Instructions / Guidelines:
Read the question paper carefully and answer the questions according to their statements.
Mobile phones are not allowed. Calculators must not have any data/equations etc. in their memory.
Note: Attempt All the Questions.
Terminal LAB Examinations FALL-2023

Q#01: Consider the topology of Figure 1 for implementation. (30)

Task 1: Create extended ACL such that block the access of 192.16.6.3 from 192.16.3.2. While
“192.16.3.2” must be able to connect with other computers of network to perform task.
Task 2: Create extended ACL such that block the access of 192.16.3.0 from 192.16.7.0 While
192.16.3.0 must be able connect with other computers of network to perform task.
Task 3: Create extended ACL such that block the 192.16.5.2 from gaining access on the
network 192.16.7.0.
Task4: Create extended ACL such that block all traffic to 192.16.7.3 from the Network of
192.16.4.0.
Task 5: Verify if the access list is created successfully. Run following command on router R1
and R2. Also write down your observations.
R1# show access-list
__________________________________________________________
R2# show access-list___________________________________________________________

Q#02: Consider the topology of Figure 2 for implementation. (20)


Task 1: Perform Basic Router Configuration
Task 2: Configure IP Addressing on the Host PCs
Task 3: Test and Verify the Configurations
Task 4: Configure a Static Route Using a Next-Hop Address.
Task 5: Test and Verify the Static Routes
Task 6: Complete the addressing table given below
Device Interface IP Address Subnet mask Default Gateway

R1 FA 0/0

S 0/0/0

R2 FA 0/0

S 0/0/0
S 0/0/1
R3 FA 0/0

S 0/0/0
PC1 FA 0

PC2 FA 0
PC3 FA 0

The End

You might also like