C Programming
Project
Implement the following Vehicle Control system with the specifications listed below:
1. Ask the user if he/she wants
a. Turn on the vehicle engine
b. Turn off the vehicle engine
c. Quit the system
2. If chose to “Quit the system”: Quit program
3. If chose to “Turn off the vehicle engine”: Ask him/her again what he/she wants to
do (Requirement 1)
4. Once a choice has been chosen, print on screen the system state.
5. If chose to “Turn on the vehicle engine”, display “Sensors set menu”, menuthat
simulates the vehicle sensors readings.
a. Turn off the engine
b. Set the traffic light color.
c. Set the room temperature (Temperature Sensor)
d. Set the engine temperature (Engine Temperature Sensor)
6. While the engine is ON, menu in requirement 5 must be always displayed and
waits for an answer.
7. Based on the answer of requirement 6.
a. Based on traffic light data (Take it as input from console, we will assume that
this is the sensor read value)
i. If the traffic light is ‘G’ set vehicle speed to 100 km/hr
ii. If the traffic light is ‘O’ set vehicle speed to 30 km/hr
iii. If the traffic light is ‘R’ set vehicle speed to 0 km/h
b. Based on room temperature data (Take it as input from console, we will assume
that this is the sensor read value)
i. If temperature less than 10, Turn AC ON and set
temperature to 20
ii. If temperature is greater than 30, Turn AC ON and set
temperature to 20
iii. If temperature is otherwise, Turn AC OFF
c. Based on engine temperature data (Take it as input from console, we will
assume that this is the sensor read value)
i. If temperature less than 100, Turn “Engine Temperature
Controller” ON and set temperature to 125
ii. If temperature is greater than 150, Turn “Engine Temperature
Controller” ON and set temperature to 125
iii. If temperature is otherwise, Turn “Engine Temperature
Controller” OFF
d. If vehicle speed is 30 km/hr
i. Turn ON AC if it was OFF and set room temperature to: current
temperature * (5/4) + 1
ii. Turn ON “Engine Temperature Controller” if it was OFF and set engine
temperature to: current temperature * (5/4) + 1
e. Display the current vehicle state after applying 7.a to 7.d
i. Engine state: ON/OFF.
ii. AC: ON/OFF.
iii. Vehicle Speed.
iv. Room Temperature.
v. Engine Temperature Controller State.
vi. Engine Temperature.
8. If chose in menu of requirement 5 to “Turn off the engine”, the menu of
requirement 1 must be displayed.
9. Bonus Requirement: Create #define WITH_ENGINE_TEMP_CONTROLLER, if this
#define is 1 then compile/run the code lines that are related to the “Engine
Temperature Controller, else do not compile/run. (Code that implements 5-d, 7-c,
7-d-ii, 7-e-v and 7-e-vi)
10. Check this video: https://youtu.be/i89M2azHeWM
Notes
• To get an character input use:
printf("a. Turn on the vehicle engine\n");
printf("b. Turn off the vehicle engine\n");
printf("c. Quit the system\n\n");
scanf(“ %c”,&input);
Make sure you left a space before %c to prevent scanf function from take new line or
enter from the above printf functions as input.
• For the bonus requirement, search for how to use preprocessor directive like below in
C Language.
#if (CONDITION)
…
#endif
This topic will be discussed later in C For Embedded Systems (Embedded C) Course.
Thanks and Good Luck
Eng / Mohamed Tarek
