Scribd Logo
Upload

Welcome to Scribd!

  • 34 views

    ML C 650 c65mm223

    Uploaded by

    operaciones

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    ML C 650 c65mm223

    Uploaded by

    operaciones
    34 views2 pages

    Original Title

    ml-c-650-c65mm223

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    34 views2 pages

    ML C 650 c65mm223

    Uploaded by

    operaciones

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    Model 650 Maintenance Manual (Rev 38)

    21-51-03 (Rev 38)

    VAPOR CYCLE COOLING SYSTEM - INSPECTION/CHECK


    1. General
    A. This section gives the procedures required to complete inspections on the vapor-cycle cooling system. Additional information
    on required inspection intervals and maintenance practices can be found in the Enviro Systems Inc. Operating, Servicing, and
    Component Maintenance Manual 21-00-00 (R-12 systems), and 21-00-27 (R134a systems).
    B. Safety Precautions.
    WARNING: Obey all precautions when handling refrigerant or servicing and performing maintenance on air
    conditioning systems.
    2. Tools and Equipment
    A. For a list of required tools and equipment, refer to Air Conditioning - General.
    TASK 21-51-03-210
    3. Vapor Cycle Cooling System Hour Meter Check
    A. Examine the vapor cycle cooling hour meter (if installed).
    NOTE: The intent of this inspection is to determine which vapor cycle system maintenance is due based on
    compressor hours.
    (1) If there is not a vapor cycle cooling system hour meter installed on the airplane, use one of the following methods to
    determine the compressor maintenance requirements:
    (a) Examine the airplane log book to see if the amount of time the compressor was in operation can be determined.
    (b) If you cannot positively determine the number of compressor hours on the motor, it must be assumed that the motor
    has more than 500 hours time in service.
    (c) An operator is permitted to submit a request to their local Flight Standards District Office in accordance with 14 CFR
    39.19 to propose an acceptable method of determining compressor operation time.
    (2) Get access to the vapor cycle cooling system compressor through the aft baggage compartment panels. Refer to Chapter
    6, Access Plates and Panels Identification - Description and Operation.
    (3) If installed, examine the hour meter for installation and damage.
    (4) Apply electrical power to the airplane.
    (5) Record the hours from the hour meter.
    (6) Remove electrical power from the airplane.
    (7) Refer to the Chapter 4, Airworthiness Limitations, Compressor Drive Motor Brush Replacement schedule to see if any
    requirements must be completed at this time based on compressor hours.
    (8) Complete Inspection Task 21-52-00-213 if any of the following conditions exist:
    (a) If vapor cycle system 500 compressor hour maintenance is due. Refer to Chapter 5, Components Time Limits and
    the applicable Enviro Systems Inc. Component Maintenance Manual (CMM) 21-00-00 (R-12 systems) or 21-00-27
    (R134a systems).
    (b) If vapor cycle system 500 compressor hour maintenance will become due before the next scheduled Vapor Cycle
    Cooling System Hour Meter Check.
    (c) If the last time the vapor cycle system 500 hour compressor hour maintenance was completed is not known.
    (9) Install the aft baggage compartment access panels that were removed. Refer to Chapter 6, Access Plates and Panels
    Identification - Description and Operation.
    END OF TASK
    TASK 21-51-03-211
    4. Vapor Cycle Cooling System 500 Compressor Hour Maintenance
    A. Complete the Vapor Cycle Cooling System 500 Compressor Hour Inspection and Maintenance on the Compressor Condenser
    Module. Refer to the Enviro Systems Inc. Component Maintenance Manual (CMM) 21-00-00 (R-12 systems) or 21-00-27
    (R134a systems) as applicable.
    END OF TASK
    TASK 21-51-03-212
    5. Vapor Cycle Cooling System 12 Month Maintenance

    Copyright © Textron Aviation Inc. Page 1 of 2


    Retain printed data for historical reference only. For future maintenance, use only current data. Print Date: Tue Nov 21 09:38:07 CST 2023
    Model 650 Maintenance Manual (Rev 38)
    21-51-03 (Rev 38)

    A. Complete the Vapor Cycle Cooling System 12 Month Inspection and Maintenance on the Forward and Aft Evaporator Module.
    Refer to the Enviro Systems Inc. Component Maintenance Manual (CMM) 21-00-00 (R-12 systems) or 21-00-27 (R134a
    systems) as applicable.
    B. Examine the vapor cycle cooling system hour meter (if installed)
    (1) Get access to the vapor cycle cooling system compressor through the aft baggage compartment panels. Refer to Chapter
    6, Access Plates and Panels Identification - Description and Operation.
    (2) If installed, examine the hour meter for installation and damage.
    (3) Apply electrical power to the airplane.
    (4) Record the hours from the hour meter.
    (5) Remove electrical power from the airplane.
    (6) Install the aft baggage compartment access panels that were removed. Refer to Chapter 6, Access Plates and Panels
    Identification - Description and Operation.
    END OF TASK

    Copyright © Textron Aviation Inc. Page 2 of 2


    Retain printed data for historical reference only. For future maintenance, use only current data. Print Date: Tue Nov 21 09:38:07 CST 2023

    You might also like