Scribd
Upload
1K views3 pages

To Find Resistance of A Given Wire - Standard Resistor Using Metre Bridge

The document describes an experiment to measure the resistance of a wire or standard resistor using a meter bridge. Key steps include: 1. Setting up the meter bridge apparatus with a galvanometer, resistance box, and unknown resistor or wire. 2. Taking measurements of the null point location for different resistor values and calculating the unknown resistance using Wheatstone's bridge formula. 3. Repeating the process for different lengths of the unknown wire and calculating the average measured resistance.

Uploaded by

atikshpro3004
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views3 pages

To Find Resistance of A Given Wire - Standard Resistor Using Metre Bridge

The document describes an experiment to measure the resistance of a wire or standard resistor using a meter bridge. Key steps include: 1. Setting up the meter bridge apparatus with a galvanometer, resistance box, and unknown resistor or wire. 2. Taking measurements of the null point location for different resistor values and calculating the unknown resistance using Wheatstone's bridge formula. 3. Repeating the process for different lengths of the unknown wire and calculating the average measured resistance.

Uploaded by

atikshpro3004
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

EXPERIMENT -1

AIM:

To find resistance of a given wire / standard resistor using metre bridge.

Materials Required:

A metre bridge, Ba:ery eliminator, Galvanometer, Resistance box, Jockey, One-way key,
Resistance wire, Metre scale, ConnecFng wires (Copper), A piece of sandpaper

Theory:

Metre bridge apparatus is also known as a slide wire bridge. It is fixed on the wooden block
and consists of a long wire with a uniform cross-secFonal area. It has two gaps formed using
thick metal strips to make the Wheatstone's bridge.

Then according to Wheatstone's principle:

! #
"
= (%&&'#)

The unknown resistance can be calculated as:


#
X = R(%&&'#)

Circuit Diagram:
ObservaCons:

Length of given wire; l: ______________ cm

Table for unknown resistance (X)

S. No. Resistance from Length AB = l Length BC = Unknown


box, R (Ohm) (cm) (100-l) (cm) Resistance X = X
#
= R(%&&'#)
(Ohm)
1.
2.
3.
4.
5.

CalculaCons for X (unknown resistance):

X1 =
X2 =
X3 =
X4 =
X5 =

Mean X: (X1 + X2 + X3 + X4 + X5)/5 = _______ ohm

Result:

The value of unknown resistance X = _________ ohm

PrecauCons:

1. The connecFons should be neat, Fght and clean.

2. Plugs should be Fghtly connected in the resistance box.

3. The movement of the jockey should be gentle and it shouldn't be rubbed.

4. The key K should be inserted only when the observaFons are to be taken.

5. The null point should be between 45cm and 55cm.

6. To avoid the error of parallax, the set square should be used to note the null point.
7. There shouldn't be any loops in the wire.

Sources Of Error:

1. The screws of the instrument might be loose

2. The wire might be of non-uniform diameter.

You might also like