Dresinate TX - TDS (En)

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Technical Data Sheet

Dresinate™ TX Rosin Soap

Applications Key Attributes


Adhesives/sealants-B&C Dry, free flowing powder
Bookbinding Fully saponified sodium salt of tall oil
Caps & lids non-food contact Readily dissolves in water
Carpet construction
Case and carton closures
Commerical printing inks
Concrete
Film modification
Labels non food contact
Packaging component films
Packaging components non food contact
Packaging tape
Paints & coatings
Polymer modification
Protective coatings
Road markings
Roofing ingredients
Solder flux
Specialty tape
Tape non food contact
Tires
Wax ingredients
Wire/cable

Product Description
Dresinate™ TX tall oil soap is a free flowing solid, fully saponified sodium soap of tall oil. It is designed mainly as
an emulsifier promoting detergent or cleaning activity, particularly in highly built industrial metal cleaners.

Typical Properties

Propertya Typical Value, Unitsb


General
Soap Type Sodium
Total solids content 96 %
Water Content 4%
pH of water solution
@ 0.5% 9.1
@ 5.0% 9.4
Appearance Small flakes
Color brown
Acid Number (min.) 0.5

aUnless noted otherwise, all tests are run at 23°C (73°F) and 50% relative humidity.
bUnits are in SI or US customary units.

Compatibility and Solubility


Compatible in built cleaner products with sodium hydroxide, sodium carbonate, sodium metasilicate, sodium
orthosilicate, trisodium phosphate, polyphosphate sequestering agents, and synthetic wetting agents.

PDFCROWD.COM
Soluble in water and aqueous solutions of alcohols and glycols. For example, a 10% concentration in water at 70°F
(21°C) can be prepared in less than 10 minutes by slowly adding the Dresinate TX tall oil soap to agitated water.

Packaging
Powder; in multiwall, moisture resistant paper bags (40 lbs, 18.1 kg, net wt). See SDS for additional property and
handling information.

Storage
Due to the thermoplastic behavior, pastillated and flaked resins may fuse, block or lump. This can be accelerated
under any of the following conditions: 1) above ambient temperature, 2) prolonged storage, 3) pressure, e.g.,
stacking pallets, or a combination of these conditions. This is particularly applicable for low softening point resin
grades.

In order to maintain the flake or pastille shape, we therefore recommend storing the material in a temperature-
controlled area, be careful with stacking material or applying pressure and preventing prolonged storage.

It should be noted that lumping does not have a negative impact on the product specifications. Due to the nature
of the product, claims regarding lumping cannot be accepted.

Resins are prone to gradual oxidation, some more so than others. This could result in darkening and/or it could
have an adverse effect on the solubility of the resin in organic solvents or on its compatibility with polymers.
Accordingly, it is recommended that strict control of inventory be observed at all times, taking care that the oldest
material is used first.

Eastman and its marketing affiliates shall not be responsible for the use of this information, or of any product, method, or apparatus mentioned, and
you must make your own determination of its suitability and completeness for your own use, for the protection of the environment, and for the health
and safety of your employees and purchasers of your products. No warranty is made of the merchantability of fitness of any product, and nothing
herein waives any of the Seller's conditions of sale.

2/28/2018 11:35:39 AM

© 2020 Eastman Chemical Company or its subsidiaries. All rights reserved. As used herein, ® denotes registered trademark status in the U.S.
only.

PDFCROWD.COM

You might also like