Moving Charges and Magnetism Formula Sheet

Moving charges and magnetism
Formula sheet
Biot Savart’s law
μo  idlsinθ 
dB   
4π  r 2 
Where θ is the angle between r and dl and μo  4π  107 TmA 1 is called magnetic permeability of
free space.
In vector form
 μ I  dl  r 
dB  o
4π r 3
Applications of Biot Savart’s law
Magnetic field at the centre of a circular loop carrying current
μoI
B
2r
Magnetic field due to arc
μoI
B θ
4πr
Magnetic field due to a straight conductor
Magnetic field at point P at a perpendicular distance r from from a

straight cinductor carrying current I is
μoI
B  sinφ1  sinφ2 
4πr
Special cases
When length of wire is infinite (or very long) and distance r is very small then
 If P lies near one end , then φ1  90o and φ2  0o
μoI
so, B 
4πr

sin90o  sin0o 
μoI
 B
4πr
 If P lies near centre, then φ1  90o and φ2  90o
μoI
so, B 
4πr

sin90o  sin90o 
μoI
 B
2πr
Magnetic field on the axis of a circular loop
NμoIr 2
B 3
.

2 r x 2 2 2

Which is directed along the axis (a) towards the loop if current in it is in a clockwise direction (b)
away from the loop if current in it is in anticlockwise direction.
Where
N = no. of turns in the loop
I = current in the loop
R = radius of the loop
x = distance of point from centre of the loop on the axis
Direction of magnetic field

Right hand thumb rule or right hand grip rule or right hand palm rule
It states that if we hold a current I carrying wire in our right hand, such that the thumb points in the
direction of current, then the curled fingers around it give us the direction of magnetic field lines
around it.
Ampere’s circuital law
It states that the line integral of magnetic field intensity over a closed loop is μo times the total
current threading the loop.

 
 B.dl  μoI
Magnetic field intensity at the centre of a long solenoid
B  μonI
1
Note: at the ends of the solenoid the magnetic field is B  μonI
2
Force acting on a charged particle moving in a magnetic field
If a charge q is moving with velocity v in a magnetic field of intensity B such that the angle
between velocity vector and magnetic field vector is θ, then a force F acts on the particle such that
F  qvB sinθ
 F  qvB sinθ
As the value of constant in this relation is 1 in SI units.
In vector form
  
 
F  q v  B , thus F is perpendicular to the plane containing v and B.
Direction of F can be found by Fleming’s left hand rule
It states that stretch the thumb, forefinger, and central finger

of the left hand in a mutually perpendicular position such that
the forefinger is pointing towards the direction of the
magnetic field, central finger pointing towards the direction
of motion of positive charge (direction of current) then the
direction of thumb gives the direction of force acting on the
particle.
If a
charge q enters perpendicularly into a magnetic field, then its path

will be circular as force always acts in a direction perpendicular to
the direction of motion of motion of the charge. Centripetal force
required for circular motion is provided by the magnetic force acting
on the particle. Thus
mv 2
 q vB
r
mv
 qB
r
1. Radius of the path (r)

mv
r
Bq
2. Velocity (v)
Bqr
v
m
3. Time period (T)
2πr 2π r 2πm
T  
v Bq r Bq
m
4. Frequency
1 Bq
v 
T 2πm
5. Angular frequency
Bq Bq
ω  2πv  2π  
2πm m
6. Kinetic energy
2
1 1  Bqr 
KE  mv 2  m 
2 2  m 
1 B2q2r 2 1 B2qr r 2
 KE  m 
2 m2 2 m
If charge particle enters at an angle with the direction of

magnetic field then split its velocity into rectangular
components v cos θ along the field and v sinθ
perpendicular the field as shown. Due to these two
components, the motion of the charge is helical.
Distance between two turns of the helix is called pitch(d) which is given by
2πm
d  v cosθ  time period  v cosθ 
Bq
Lorentz force
Force acting on a particle in a region where both electric and magnetic fields exist is called Lorentz
force. Lorentz force is the resultant of electric and magnetic force acting on the particle.
 
F  FE  FB
  

F  qE  q v  B 
Velocity selector or velocity filter
Consider a situation as shown in the figure in a charge is moving perpendicularly to both electric
and magnetic fields such the force the force
acting on charge due to both the fields is equal
and opposite i.e.
qE = qvB
E
v 
B
This result is used in velocity selectors or velocity filters in which we have to select a particle with a
particular value of velocity.
Force acting on a current carrying conductor placed in a magnetic field
F  IB sinθ
Force between two parallel straight conductors carrying current
F1 F2 μoI1I2
 
  2πr
When the currents are in same direction
conductors attract each other and when
currents are in opposite direction
conductors repel each other.
Torque acting on a current carrying conductor placed in a magnetic field
τ  NIAB sinθ .
 
In vector form τ  M  B where M = NIA is called magnetic dipole moment of current loop abd is directed in
direction of area vector.
Moving coil galvanometer
k
G , G is called galvanometer constant.
NAB
So measuring by deflection α, we can measure current I passing through the coil.
Current sensitivity (Is)
It is defined as the deflection produced in the galvanometer coil when unit current is passed through it.
θ
Thus Is  . SI unit is rad/A.
I
θ 1 NAB
since   therefore, the increase current sensitivity we should
I G k
 Increase N which is not possible beyond a certain limit as it makes galvanometer bulky.
 Increase A which is not possible beyond a certain limit due to space.
 Increase B
 Decrease k, so we use phosphor bronze strip in galvanometer because it has very small k.
Voltage sensitivity ( Vs )
Is the defined as the deflection produced in galvanometer coil when unit voltage is applied across its
θ
terminals. Vs  . SI unit is rad/V.
V
Conversion of galvanometer into ammeter
A galvanometer can be converted into ammeter by connecting a low shunt resistance in parallel with it, so
that most of the current by passes through the shunt resistance, enabling the galvanometer to measure much
larger currents.
Thus if a galvanometer of resistance Rg which gives full scale deflection at Ig is to be used to convert into an
ammeter capable of measuring a maximum current I , we connect a shunt resistance R in parallel with it
which is obtained as
VR  VG
 I  Ig  R  IgRg
IgR g
 R
I  Ig
Conversion of galvanometer into voltmeter
A galvanometer can be converted into voltmeter by connecting high resistance in series with it, so that most
of the voltage applied drops across it, enabling the galvanometer to measure much larger voltages.
Thus is the galvanometer of resistance R g which gives full deflection at current Ig , is to be converted into
voltmeter capable of measuring maximum voltage up to V volts, then a high resistance R is connected in
series with it which is given by
V  IgRg  IgR or V  IgRg  IgR

V
or R   Rg
Ig

Moving Charges and Magnetism Formula Sheet

Uploaded by

Copyright:

Available Formats

Moving Charges and Magnetism Formula Sheet

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Moving Charges and Magnetism Formula Sheet

Uploaded by

Copyright:

Available Formats

Moving charges and magnetism

Biot Savart’s law

Applications of Biot Savart’s law

Magnetic field at the centre of a circular loop carrying current

Magnetic field due to arc

Magnetic field at point P at a perpendicular distance r from from a

 If P lies near one end , then φ1  90o and φ2  0o

 If P lies near centre, then φ1  90o and φ2  90o

Magnetic field on the axis of a circular loop

N = no. of turns in the loop

I = current in the loop

R = radius of the loop

x = distance of point from centre of the loop on the axis

Direction of magnetic field

Ampere’s circuital law

current threading the loop.

Magnetic field intensity at the centre of a long solenoid

Force acting on a charged particle moving in a magnetic field

As the value of constant in this relation is 1 in SI units.

Direction of F can be found by Fleming’s left hand rule

It states that stretch the thumb, forefinger, and central finger

charge q enters perpendicularly into a magnetic field, then its path

1. Radius of the path (r)

If charge particle enters at an angle with the direction of

Force acting on a current carrying conductor placed in a magnetic field

Force between two parallel straight conductors carrying current

Torque acting on a current carrying conductor placed in a magnetic field

Moving coil galvanometer

So measuring by deflection α, we can measure current I passing through the coil.

Current sensitivity (Is)

Conversion of galvanometer into ammeter

Conversion of galvanometer into voltmeter

V  IgRg  IgR or V  IgRg  IgR

You might also like