Scribd
Upload
639 views1 page

Surface Tester Work Instructions

The document provides work instructions for using a Taylor Hobson surtronic 3+ surface roughness tester. It outlines 11 steps for initializing the device, calibrating it with a reference specimen, adjusting settings based on the surface to be measured, placing the stylus on the surface, starting the measurement process, and viewing results on the screen. The instructions are for measuring surface roughness according to ISO-4288 standards and have been prepared and approved by trained operators.

Uploaded by

Abdul Ahad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
639 views1 page

Surface Tester Work Instructions

The document provides work instructions for using a Taylor Hobson surtronic 3+ surface roughness tester. It outlines 11 steps for initializing the device, calibrating it with a reference specimen, adjusting settings based on the surface to be measured, placing the stylus on the surface, starting the measurement process, and viewing results on the screen. The instructions are for measuring surface roughness according to ISO-4288 standards and have been prepared and approved by trained operators.

Uploaded by

Abdul Ahad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Work Instructions

Device Name: Surface Roughness Tester


Model: Taylor Hobson surtronic 3+

Steps:
1. Place surface roughness tester on smooth table.
2. Press ON Key to initialize the device.
3. Press set key along with Functional keys [∆] for making
selection related to measurement conditions and evaluation
parameters.
4. Adjust Cut off length LC according to the table no 1 [EN ISO-4288]

5. Calibrate Surface tester with reference specimen [Type-112/1534].


6. Place your work-piece on smooth and flat surface.
7. Adjust cut off length LC according to the surface need to be
measured.
8. Place PICK UP stylus point on the surface need to be measured.
9. Press start button to initiate the process.
10. Wait till stylus complete its Traversing length.
Table no: 1
11. Final Result display on the screen.
Trained Operators

__________________ ____________________
Prepared By: Approved By:

You might also like