Multi-channel measurement card ML801B (continued)

ML801B + connection board AP815i

Accuracy class 0.11)2)3)
Transducers that can be connected 8 SG full bridges in 6-wire configuration or
8 SG half bridges in 6-wire configuration or
8 SG half bridges in 5-wire configuration or
8 SG quarter bridges in 4-wire configuration or
2 SG rosettes
Internal completion resistors Ω 120, 350, 700, (optionally 1000)
Total transducer resistance with half and full bridges Ω 240 … 4000
(2x120 ... 2000 with half bridges; 4x240 ... 4000 with
full bridges)
Bridge excitation voltage (DC) V 5; 2.5; 1; 0.5
Measuring ranges mV/V ±8 (UB=5 V)
±16 (UB=2.5 V)
±40 (UB=1 V)
±80 (UB=0.5 V)
Control signal (shunt) mV/V 1.0078 ±0.1 % (at 350 Ω)
Noise at 350 Ω
Filter characteristics Bessel/Butterworth
Filter frequency Hz 1.25/5 40/80 200/500
UB=5 V μV/VSS <±0.1 <±0.6 <±4
UB=2.5 V μV/VSS <±0.2 <±1.2 <±8
UB=1 V μV/VSS <±0.5 <±3 <±20
UB=0.5 V μV/VSS <±1 <±6 <±40
Transducer connection Two D jacks, 25-pin (4 channels each)
Allowed cable length between transducer and connection
board m 2004)
Width mm 20.3 (4 HP)
Non-linearity % 0.05
Measurement frequency range Hz 1000 (-1 dB)
Effect of 10 K change in ambient temperature
on the zero point (relative to the full scale value) % 0.12)
on sensitivity % 0.1
Operating temperature range °C -20 … +60
1) 0.2 with irradiation as per EN 61000‐4‐3:1996 + A1:1998
2) 0.2 with 5 V bridge excitation voltage
3) If zero balancing is not possible, the following accuracy classes apply: 0.2 with R
transducer > 2 kΩ and 0.3 with Rtransducer > 3 kΩ.
4) 100 m max. distance between connection board and T-ID/TEDS module

B00554_30_E00_01 16.03.2022 HBM: public 25 HBM