Module 4 :

Lasers
1
 Introduction to LASERS
• The word LASER is an acronym for Light Amplification by
Stimulated Emission of Radiation. Laser is a device that
amplifies or increases the intensity of light and produces highly
directional light.
• LASER also generate light by the process known as stimulated
emission of radiation (photons)
• Some lasers generate visible light but others generate
ultraviolet or infrared rays which are invisible
• lasers produce highly directional, monochromatic, coherent and
polarized light beam.

2
 Fundamental process of laser
action
When light interact with matter three fundamental processes can happen

• Absorption

• Spontaneous emission

• Stimulated emission

3
 Stimulated Absorption

The rate of absorption can be defined as

Rab = B12  ( )N1

 ( ) Is the photon intensity N1 Number of atoms in the ground state 4

B12 Einstein coefficient of absorption

 Spontaneous Emission

The rate of spontaneous emission can be defined as

Rsp= A21 N2
A12 Einstein coefficient of Spontaneous emission
5
N 2 Number of atoms in the excited state
Note: Life time of atoms in the excited state is approximately 10-8s
 Spontaneous Emission
Characteristics of spontaneous emission

• The emission is fully probabilistic, not controlled by external forces

• The direction, instant of transition, initial phase and plane of

polarization all are random

• Light is not monochromatic and incoherent

• Light spreads in all directions and it attenuate rapidly with

distance

6
 STIMULATED Emission

The rate of stimulated emission can be defined as

Rab = B21 ( )N 2
B21 Einstein coefficient of stimulated emission 7

Note: Life time of atoms in the excited state is approximately 10-3s

 Characteristics of STIMULATED
Emission
• The process of stimulated emission can be controllable
• The emitting photons will be in same direction, initial phase,
polarization and frequency as that of the incident photon
• Multiplication of Photons: The photon emitted interact with
another photon and produce stimulated emission producing two
photons. These stimulated photons stimulate further emissions
and produce an avalanche effect.
• Light Amplification: Since the photon have same initial phase,
they will interfere constructively and amplify the photon
intensity

8
Relation b/n Einstein Coefficients
Under equilibrium condition, the rate of absorption should be equal to the rate of
total emission from the system (i.e, spontaneous emission + stimulated emission )

i.e Rab = Rspon + Rsti

or B12 N1  ( ) = A21 N 2 + B21 N 2  ( ) Eqn (1)

 ( ) =
A21 N 2
This can be rearranged as follows Eqn (2)
B12 N1 − B21 N 2

Dividing by B21 N 2 = A /B {1/N /N (B /B -1))

21 21 1 2 12 21 Eqn (3)

From Boltzmann's distribution law, the ratio of populations of two levels at

temperature T is expressed as 9

N2 − E − h Where, K is the Boltzmann's constant and

= e KT = e KT h is the Planck’s constant.
N1
Relation b/n Einstein Coefficients
Substituting in Eqn (3)
A21
 ( ) =
B12
h
Eqn (4)
B21
e KT
− B12
Now according to Planck’s radiation law, the energy density of the black body
radiation of frequency v at temperature T is given as
ρ (υ)= 8πhv3/c3(1/ehv/KT) Eqn (5)

Comparing Eqn (4) and (5)

B21 A21/B21=8πhv3/c3 Eqn (6)
=1 and
B12

We get
(i) B12 = B21, The probability of spontaneous emission is same as that of induced absorption.
This means that if these two processes will occur at equal rates,
so that no population inversion can be attained in a two-level system.
10
(ii) The ratio of spontaneous emission and stimulated emission is proportional to v3.
This implies that the probability of spontaneous emission dominates over induced
emission more and more as the energy difference between the two states increases.
11
12
13
14
 Significance of Einstein Coefficients
Since the Einstein coefficients are properties of single atoms,
ions and molecules, and since a single particle has no way of
"knowing" whether or not it is in thermodynamic
equilibrium, these relationships must hold in general, i.e., even
if the radiating/absorbing particles are not in a state of
thermodynamic equilibrium

Eqn (6) shows that the ratio of Einstein’s coefficient of

spontaneous emission to the Einstein’s coefficient of stimulated
absorption is proportional to cube of frequency. It means that at
thermal equilibrium, the probability of spontaneous emission
increases rapidly with the energy difference between two 15
states.
 Laser Action
• At normal condition,
the No: of atoms in the ground state
should be > the No: of atoms in the excited state.

• A high intensity photons interact with the matter always

increase the process of absorption within the matter.
Similarly, the atoms in the excited state tends to jumps to
the ground state through spontaneous emission. Hence, at
normal condition the probability of absorption and
spontaneous emission will be dominant as compared to
stimulated emission

• In order to produce a laser action, the rate of stimulated

emission should be dominant as compared to the rate of 16
absorption and/or the rate of spontaneous emission
 Laser Action
• For laser action : Two factors plays an important role. (A)
ratio of stimulated emission to spontaneous emission , R1
(B) ratio of stimulated emission to rate of absorption, R2
• (A) Ratio of stimulated emission to spontaneous emission

Rsti B  ( )N 2 B21
R1 = = 21 =  ( ) Eqn (7)
Rspont A21 N 2 A21

Using Eqn (6) and rearranging

1
R1 = h Eqn (8) 17
e KT
−1
 Laser Action
• (B) Ratio of stimulated emission to Absorption
B21 N 2  ( ) B21 N 2
R2 = =
B12 N1  ( ) B12 N1
N2
R2 = Eqn (9)
N1

Hence by analysing Eqn (7) and Eqn (9), we can suggest three
conditions to produce laser action (high degree of stimulated
emission)
1. N2>N1

B21
2. A21
Should be larger
18

Should have high intensity

3.  ( )
 Laser action

The conditions for the commencement of laser action mentioned in the

previous slides can be achieved by

1. Population inversion

2. Introduction of metastable states

3. Use of Optical Resonant Cavity

19
 Three level pumping system
❑ The atom in the ground state absorbs
Photons and excited to the high energy unstable
state

❑ From the higher unstable energy state the

atoms undergo spontaneous emission and
collected in the metastable state

❑ The number of atoms in the metastable state

increase because of the longer lifetime at the
metastable state

❑ Population inversion is achieved between the

ground state and the metastable state

20
Laser action is taken place between ground state and
higher metastable energy level
 Four level pumping system
❑ The four level pumping system
contains four energy levels E1 E2 E3
and E4 with number of atoms at each
level N1 N2 N3 and N4 respectively

❑ The pumping photons excite the

ground level atoms into the upper
excited level (E4)
❑ From level 4 the atoms decays to level 3, which is the upper excited
level of the metastable state. The decay is fast and non-radioative

❑ Since the life time of the atoms in the metastable state is higher ,
atoms starts accumulating in level 3 and this atoms decays to level 2
by spontaneous or stimulated emission

❑ From level 2 the atoms de-excite to ground state by fast and non –
radioactive decay.
21
❑ The population inversion is achieved between level 3 and level 2.
Comparison of different pumping
schemes

22
 LASERS
LASERS can be classified according to

(a) active medium

➢ Solid state lasers

➢ Gas lasers
➢ Semiconductor
➢ Liquid dye laser

(b) output

➢ Continuous-wave laser
➢ Pulsed laser
23
 Gas LASERs
• A gas laser is a type of laser in which a mixture of gas is used as
the active medium or laser medium. Gas lasers are the most
widely used lasers.

• Gas lasers range from the low power helium-neon lasers to the
very high power carbon dioxide lasers. The helium-neon lasers
are most commonly used in college laboratories whereas the
carbon dioxide lasers are used in industrial applications.

• The main advantage of gas lasers (eg: He-Ne lasers) over solid
state lasers is that they are less prone to damage by overheating
so they can be run continuously.
24
 Helium neon laser
• Helium-Neon laser is a type of gas laser in which a mixture of
helium and neon gas is used as a active medium.
• The helium-neon laser was the first continuous wave (CW)
laser ever constructed. It was built in 1961 by Ali Javan,
Bennett, and Herriott at Bell Telephone Laboratories.
• He-Ne laser is a four-level laser
• The helium-neon laser operates at a wavelength of 632.8
nanometers (nm), in the red portion of the visible spectrum.

25
 Helium neon laser-Construction
• The setup consists of a discharge tube of
length 80 cm and bore diameter of
1.5cm.
• The active medium of the laser is a
mixture of helium and neon gases, in a
5:1 to 20:1 ratio, contained at low
pressure in a glass envelope.

• The optical cavity of the laser typically consists of a plane, high-reflecting

mirror at one end of the laser tube, and a concave output coupler mirror
of approximately 1% transmission at the other end.
• HeNe lasers are normally small, with cavity lengths of around 15 cm up
to 0.5 m, and optical output powers ranging from 1 mW to 100 mW.

26
27
28
29
Helium neon laser-Working

30
Application of Helium neon laser
• The Narrow red beam of He-Ne laser is used in
supermarkets to read bar codes.

• The He- Ne Laser is used in Holography in

producing the 3D images of objects.

• He-Ne lasers have many industrial and scientific

uses, and are often used in laboratory
demonstrations of optics

31
Carbon Dioxide (Co2) Laser
• Carbon dioxide lasers are gas lasers which emit infrared
radiation

• Active medium is a mixture of Co2 , N2 and He

• The proportion depends upon the laser system and excitation

mechanism. In general for a continuous laser it will be 1:2:3

• The laser transition takes place between the vibrational states

of CO2 molecules within the same electronic states

32
Carbon Dioxide (Co2) Laser

33
 Construction

It consists of a quartz tube 5 m long and 2.5 cm in the

diameter.

This discharge tube is filled with gaseous mixture of

CO2(active medium), helium and nitrogen with suitable
partial pressures
34
The terminals of the discharge tubes are connected to a
D.C power supply
35
36
37
38
39
40
41
Working Principle

42
Working Principle

43
 Application of CO2 laser

• High Powered lasers- material processing applications such as

welding, cutting etc.

• Water is capable of absorbing CO2 laser- Surgical procedures

• Used in military applications

44
 Semiconductors
• Materials can be classified in to three categories

(A) Conductors – The materials with no band gap hence

electrons can move freely

(B) Insulators- The materials with a large band gap hence

prevent the motion of electrons

(C) Semiconductors – The materials having a small band

gap, and the flow of electrons and electron holes can be
controlled by adding impurities to the material

45
46
47
48
49
50
51