BREECHING INLET CABINET

GENERAL
“AE” range of 2-way (Fig.200 and Fig.210) and 4-way (Fig.220 and
Fig.230) breeching inlet cabinets are generally fabricated from
electro-galvanised steel material. Aluminium or stainless steel
materials are available upon request.

The breeching inlet cabinets are manufactured strictly in accordance

with BS 5041 : Part 5 : 1974.

The door hinges are either riveted or welded to the cabinet and
swings out 180 degree from left to right. The cabinet comes with Fig.200
a standard springlock and 6mm thick wire glass. The wordings on
the glass vary according to the fire protection systems in which the
breeching inlet is installed, eg. DRY RISER INLET, WET RISER INLET,
SPRINKLER BREECHING INLET, FOAM INLET, etc.

The rear of the cabinet panel has the cut-out holes for easy installa-
tion of the breeching inlet to the pipework.

The quality of workmanship and its’ finishes are carefully planned

and executed from the initial stage of preparing the material and
fabricating up to the painting process.

The standard finishes of the electro-galvanised steel and aluminium

Fig.210
cabinets are “Red” epoxy/polyester powder coated and oven baked.
Stainless steel cabinets come with 4B quality finishes.

FEATURES
• Compact and elegant design.
• Quality finishes in epoxy/polyester powder coated and
oven baked.
• Easy installation with pre-cut flange holes at the rear panel.

Fig.220

Fig.230
BREECHING INLET CABINET

“Surface” Type Breeching Inlet Cabinet

FRONT ELEVATION SECTION VIEW REAR VIEW

595mm 295mm
20mm

185mm
8 nos x 22mm
bolt holes
PCD = 180mm dia

370mm
Fig.200 395mm

185mm
100mm cut-out hole

20mm 25mm

6mm wire glass 240mm 355mm

Springlock

595mm 295mm 255mm 340mm

20mm

8 nos x 22mm

255mm
bolt holes
PCD = 240mm dia

Fig.220 595mm 570mm

315mm
150mm cut-out hole

20mm 25mm

6mm wire glass

Springlock

“Recessed” Type Breeching Inlet Cabinet

FRONT ELEVATION SECTION VIEW REAR VIEW

38mm 38mm
595mm 295mm

38mm
8 nos x 22mm
185mm

bolt holes
PCD = 180mm dia

Fig.210 395mm 370mm

185mm

100mm cut-out hole

25mm
38mm

6mm wire glass 240mm 355mm

Springlock

38mm 38mm
595mm 295mm 255mm 340mm

38mm

8 nos x 22mm
255mm

bolt holes
PCD = 240mm dia

Fig.230 595mm 570mm

315mm

150mm cut-out hole

25mm
38mm

6mm wire glass

Springlock

* All dimensions shown are in millimetres.

* Due to the improvement in the design and standard, we reserve the right to change the specifications without prior notice.