Scribd
Upload
30 views6 pages

7.10 Technical Report: Figure# 7.6 Simulation

The document describes simulations of a circuit using a Zener diode and resistor as the input voltage is varied from 1V to 20V. For each input voltage, the output voltage across the Zener diode is measured and depicted in a corresponding figure. The circuit is also constructed with different resistor values and multiple Zener diodes, and additional simulations are run to measure the output voltage at various input voltages.

Uploaded by

Fawad Shakil Asghar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
30 views6 pages

7.10 Technical Report: Figure# 7.6 Simulation

The document describes simulations of a circuit using a Zener diode and resistor as the input voltage is varied from 1V to 20V. For each input voltage, the output voltage across the Zener diode is measured and depicted in a corresponding figure. The circuit is also constructed with different resistor values and multiple Zener diodes, and additional simulations are run to measure the output voltage at various input voltages.

Uploaded by

Fawad Shakil Asghar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

7.

10 Technical report
Consider the circuit using figure 7.1 with a resistor of 2.2kohm. when the voltage is positive the diode
(Zener Diode) is reverse biaised. Until the zener potential is reached the diode resistance is very high
and no current flows. In this condition ohm’s law makes the voltage across R zero so all E appear across
the zener. Once the E exceed the zener voltage the remaining E drops across R.

When the input Voltage is 1V then the output across Zener Diode is in figure 7.6

Figure# 7.6 Simulation

When the input Voltage is 2V then the output across Zener Diode is in figure 7.7

Figure# 7.7 Simulation


When the input Voltage is 5V then the output across Zener Diode is in figure 7.8

Figure# 7.8 Simulation

When the input Voltage is 10V then the output across Zener Diode is in figure 7.9

Figure# 7.9 Simulation


When the input Voltage is 15V then the output across Zener Diode is in figure 7.10

Figure# 7.10 Simulation

When the input Voltage is 20V then the output across Zener Diode is in figure 7.11

Figure# 7.11 Simulation


 Build the figure 7.2 by using resistor of 2.2Kohm and 4.7Kohm and Zener diodes.

When the input Voltage is 2V then the output across Zener Diode is in figure 7.12

Figure# 7.12 Simulation

When the input Voltage is 5V then the output across Zener Diode is in figure 7.13

Figure# 7.13 Simulation


When the input Voltage is 10V then the output across Zener Diode is in figure 7.14

Figure# 7.14 Simulation

When the input Voltage is 15V then the output across Zener Diode is in figure 7.15

Figure# 7.15 Simulation


When the input Voltage is 20V then the output across Zener Diode is in figure 7.16

Figure# 7.16 Simulation

You might also like