0953B Forumlok GHS EN

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

19950-B: Forumlok (Hardener)

Safety Data Sheet

1. IDENTIFICATION OF THE SUBSTANCE/MIXTURE AND OF THE


COMPANY/UNDERTAKING
Identification of the substance or mixture
Product Name: Forumlok (Hardener)
Product Code: 19950-B
Product Use: Thread locking compound, adhesive
Supplier: Forum Energy Technologies
10344 Sam Houston Park Drive, Suite 300
Houston, TX 77064
Tel: 713-351-7900
www.f-e-t.com

Emergency telephone number: +1 813 248 0585, 24 hours

E-mail address for questions


regarding this SDS: [email protected]

2. HAZARDS IDENTIFICATION
GHS Classification
Skin irritation (Category 2)
Serious eye damage/eye irritation (Category 1)
Skin sensitization (Category 1B)
Respiratory sensitization (Category 1B)

GHS label elements

Signal Word:
Danger
Hazard statements:
H315 – Causes skin irritation
H317 – May cause an allergic skin reaction
H318 – Causes serious eye damage
H334 – May cause allergy or asthma symptoms or respiratory difficulties if inhaled
Precautionary statements:
P280 – Wear protective gloves/protective clothing/eye protection/face protection
P302 + P352 – IF ON SKIN: Wash with plenty of soap and water

Date issued: 7 May 2020 Page 1 of 5


Revision no.: 3
19950-B: Forumlok (Hardener)
Safety Data Sheet
P305 + P351 + P338 – IF IN EYES: Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
P304 + P340 – IF INHALED: remove person to fresh air and keep comfortable for breathing.

Other hazards: None known.

3. COMPOSITION/INFORMATION ON INGREDIENTS
Amine based epoxy hardener
Hazardous components

Component Concentration
Polyethylene polyamines 10-15%
CAS-No. 68131-73-7

4. FIRST AID MEASURES


General: If exposed or concerned, get medical attention or advice.
Inhalation: Move exposed person to fresh air. If effects occur, get medical attention.
Ingestion: Wash out mouth with water. Do not induce vomiting. Get medical attention.
Skin contact: Remove contaminated clothing and shoes. Wash skin with soap and water. Get
medical attention if irritation symptoms persist.
Eye contact: Check for and remove any contact lenses. Immediately flush eyes with running water
for at least 15 minutes, keeping eyelids open. Get medical attention.
Note to physician: Treat symptomatically.

5. FIRE-FIGHTING MEASURES
Suitable media: Use dry chemical, CO2, water spray (fog) or foam.
Not suitable: Do not use water jet.
Combustion products: Carbon monoxide, carbon dioxide.
Special protective equipment Fire-fighters should wear appropriate protective equipment and self-
for fire-fighters: contained breathing apparatus with a full face-piece operated in
positive pressure mode.

6. ACCIDENTAL RELEASE MEASURES


Personal precautions: Wear appropriate personal protection equipment (see section 8).
Environmental precautions: Recover free product. Use suitable adsorbent and dispose of material
in accordance with all regulations. Keep product out of sewers and
watercourses, prevent soil penetration. Advise authorities if large
amounts of product enter waterways or extensive land areas.

7. HANDLING AND STORAGE

Date issued: 7 May 2020 Page 2 of 5


Revision no.: 3
19950-B: Forumlok (Hardener)
Safety Data Sheet
Handling: Wear appropriate personal protection equipment (see section 8). Do
not eat, drink or smoke when using. Wash thoroughly after handling.
Follow good hygiene and housekeeping practices.
Storage: Store in cool dry area in original or equivalent container in accordance
with all regulations. Do not expose to extreme heat or flame. Do not
expose to extreme cold. Store at 5 – 40°C, away from strong oxidizers
and acids.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION


Control parameters:
Chemical name CAS no. OSHA PEL ACGIH TLV
Polyethylene polyamines 68131-73-7 not established not established

Engineering controls: Use with adequate ventilation.


Eye/face protection: Safety glasses. Safety goggles where risk of splash exists. Ensure eye
bath is to hand.
Hand protection: Protective gloves. Nitrile recommended.
Skin protection: No additional protection required beyond normal industrial attire is
required.
Respiratory protection: Use a NIOSH approved respirator where air levels exceeding TWA may
exist. Organic vapor cartridges.

9. PHYSICAL AND CHEMICAL PROPERTIES


Appearance and odor: Red liquid, amine odor
pH: No data
Flash point: > 93°C (PMCC)
Evaporation rate: No data
Upper flammability limit: No data
Lower flammability limit: No data
Vapor pressure: No data
Vapor density: >1
Relative density: 1.02
Solubility: Insoluble in water, soluble in alcohols and petroleum distillates
Viscosity: 300-500 cps

10. STABILITY AND REACTIVITY


Chemical stability: Stable
Polymerization: Will not occur
Conditions to avoid: Extreme heat
Incompatible materials: Strong oxidizers
Hazardous decomposition
products: Carbon oxides, other unknown products

Date issued: 7 May 2020 Page 3 of 5


Revision no.: 3
19950-B: Forumlok (Hardener)
Safety Data Sheet

11. TOXICOLOGICAL INFORMATION


Potential acute health effects
Acute toxicity: Estimate based on similar substances: LD50 oral – rat – 1000-2000
mg/kg
Eye damage/irritation: Causes serious eye damage. Direct contact with eyes can cause
irreversible damage including blindness.
Skin corrosion/irritation: Contact may cause skin irritation with local redness.

Potential chronic health effects


Sensitization: May cause allergic skin and respiratory reactions.
Repeated dose toxicity: Except for skin and respiratory sensitization, none anticipated.
Carcinogenicity: No ingredients listed as carcinogens.
Mutagenicity: No ingredients listed as mutagens.
Reproductive toxicity: No ingredients listed as reproductive toxins.
STOT repeated exposure: No known effects.

12. ECOLOGICAL INFORMATION


Ecotoxicity: No known significant effects or critical hazards.
Persistence/degradability: No information available.
Bioaccumulative potential: No information available.
Mobility in soil: No information available.
Other adverse effects: No information available.

13. DISPOSAL CONSIDERATIONS


Waste disposal: Generation of waste should be avoided or minimized where possible.
Empty containers may contain residue. Dispose of as hazardous waste
via licensed waste disposal operator. Follow all applicable regulations.

14. TRANSPORT INFORMATION


Transport information according to ADR, RID, ADN, IMDG, ICAO, IATA: Not regulated
Transport information according to USDOT: Not regulated.

15. REGULATORY INFORMATION


US Regulations
SARA 302 Extremely Hazardous Substances: None.
SARA 313 Components: None.

State Regulations
California Prop 65: No ingredients listed.
Massachusetts Right to Know: No ingredients listed.
New Jersey Right to Know: No ingredients listed.

Date issued: 7 May 2020 Page 4 of 5


Revision no.: 3
19950-B: Forumlok (Hardener)
Safety Data Sheet
Pennsylvania RTK Hazardous Substances: No ingredients listed.

United States inventory (TSCA): All ingredients listed or exempt.

International regulations
Canada: WHMIS Classification: D1A: Material causing immediate and serious toxic effects (very
toxic). D2A: Material causing other toxic effects (Very toxic). D2B: Material causing other toxic
effects (toxic). WHMIS: This product has been classified according to the hazard criteria of the
CPR and the MSDS contains all of the information required by the CPR.
Canada DSL: All ingredients listed.

16. OTHER INFORMATION


Hazardous Material Information System (USA): HEALTH 3*
FIRE 1
REACTIVITY 0
PERSONAL PROTECTION B

National Fire Protection Association (USA): Fire


1
Health 3 0 Instability

Specific
Hazard

Revision information: Original GHS issue 12 May 2015. Rev 1: corrected GHS classification terminology
in Section 2; corrected hazardous components in Section 3 and associated information in Sections 8, 11
and 15. Rev 2: product name change in Section 1 and title. Rev 3: reviewed with no changes.

END OF SAFETY DATA SHEET

Date issued: 7 May 2020 Page 5 of 5


Revision no.: 3

You might also like