High Performance Group – Airbus H135 Quick Start Guide

HPG Airbus H135 Quick Start Guide

Step-by-step instructions to download, install and run the Airbus H135 in Microsoft Flight Simulator 2020.

Based on Version 1.3 by Hype Performance Group

Contents
HPG Airbus H135 Quick Start Guide ....................................................................................................................................... 1
1. Download from flightsim.to ....................................................................................................................................... 2
2. Unpack the zip file to your community folder ............................................................................................................ 2
3. Start (or re-start) Microsoft Flight Simulator and Select the Airbus H135 ................................................................ 3
4. Map Controls: THROTTLE AXIS ................................................................................................................................... 3
5. Map Controls: PRIMARY CONTROL SURFACES ........................................................................................................... 4
6. Pick an airport and runway and get Ready to Fly ....................................................................................................... 4
7. (Optional) Cold start power up if you started off runway .......................................................................................... 5
8. Move your throttle through: Min -> Max -> Min ....................................................................................................... 5
9. Enable FLIGHT mode using MOUSE WHEEL UP on the red/yellow ENG I or ENG II switches .................................... 6
10. Increase collective (your Throttle control) to take off and go fly! ....................................................................... 10
11. A note on control modes toggled by ‘landing gear’ buttons – XBOX, BASIC, ADV ................................................ 7
12. Higher performance mode – “NR HI” (new, v0.90) .............................................................................................. 12
13. Hotkeys ................................................................................................................................................................. 12
14. Co-Pilot and doors ................................................................................................................................................ 12
15. (OPTIONAL) EFBConnect – display webpages in the cockpit ............................................................................... 12
16. Feedback on this guide ......................................................................................................................................... 14
 High Performance Group – Airbus H135 Quick Start Guide
1. Download from flightsim.to
https://flightsim.to/file/8970/airbus-h135-helicopter-project

2. Unpack the zip file to your community folder

Unzip and place the hpg-airbus-h135 folder into your Community folder:

• For those who purchased the game from Windows Store (paste this link into File Explorer address bar):
%LocalAppData%\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalCache\Packages\Community\

• For those who purchased the game from Steam Store – look in your Steam games install folder.
 High Performance Group – Airbus H135 Quick Start Guide
NOTE: Ensure that you do not have an extra folder in the path. Community\hpg-airbus-h135\layout.json. Check that
your unzipping program did not add a second folder which will prevent the aircraft from being recognized by MSFS.

• TIP: For Advanced users that cannot locate Community folder: Enable Dev Mode, Tools -> Virtual File System,
then look at Mounted Bases.

3. Start (or re-start) Microsoft Flight Simulator and Select the Airbus H135

4. Map Controls: THROTTLE AXIS

THROTTLE AXIS => controls the helicopter ‘Collective’ => up and down

IMPORTANT NOTE – mapping ‘Throttle Axis’ Is critical, (not THROTTLE 1, 2, ….) This will control the collective pitch of
the main rotor which controls climb and descent. The H135 will manage the engine RPM automatically through the
FADEC (Full Authority Digital Engine Control).

NOTE: After the flight control module has loaded, you should see your collective move the leverl within the cockpit. If
you don’t, you should check that you don’t have a file called SimConnect.cfg in your PC’s main Documents folder. If so,
rename the file to any other name and restart the sim.
 High Performance Group – Airbus H135 Quick Start Guide
5. Map Controls: PRIMARY CONTROL SURFACES

AILERON => controls left & right sideways motion ‘cyclic’

ELEVATOR => controls forward & backwards motion ‘cyclic’

RUDDER => controls rotation ‘yaw’ (right pedal turns clockwise)

6. Pick an airport and runway and get Ready to Fly

Picking a runway start will have the engine running, switch engines to FLIGHT
 High Performance Group – Airbus H135 Quick Start Guide

7. (Optional) Cold start power up if you started off runway

Power is turned on through the overhead panel:

Note – Ctrl + 4 shortcut will show overhead switch panel:

• Switch on BATTERY (down)

o Avionics should also be on: AVIO 1 and 2 (down)

8. Move your throttle through: Min -> Max -> Min

This will remove the “COLLECTIVE POSITION UNSAFE” warning.

Note – Ctrl + 1 shortcut will show primary displays:

 High Performance Group – Airbus H135 Quick Start Guide
9. Turn on full pumps: PRIME pumps for start, and FWD and AFT pumps for flight
 High Performance Group – Airbus H135 Quick Start Guide

10. Engage the auto pilot and Stability Augmentation System

Before flight, you must first engage the system which provide stability augmentation and auto pilot functionality.

Each amber OFF must be extinguished, by pressing it. When the button is blank, it means the system is ON.
 High Performance Group – Airbus H135 Quick Start Guide
A.TRIM is required for auto pilot functionality. AP1 AP2 and BKUP each provide stability augmentation on 3 axis’ (pitch,
roll and yaw). If you disengage all of AP1, AP2 and BKUP you will be in an unstabilized configuration. Modern helicopters
are not intended to be flown like this and you should land immediately if you find all 3 systems inoperative.

When you are ready to fly, all 4 buttons will be blank:

If you see the warning AFCS DISENGAGED on the primary flight display, you should check the configuration above.

11. Enable FLIGHT mode using MOUSE WHEEL UP on the red/yellow ENG I or ENG II switches

Note – Ctrl + 3 shortcut will show ENG engine control panel:

Warm start: (from runway)

 High Performance Group – Airbus H135 Quick Start Guide
• Bring one engine from IDLE to FLIGHT to fly, or press Ctrl+E.

Cold & dark start: (from parking)

• Use your mouse wheel to bring each engine from OFF into IDLE, wait for primary display to show ‘IDLE’, then
from IDLE to FLIGHT.

Engine RPM is managed automatically based on collective input.

TIP: You can also press Ctrl+E to get going right away, or click READY FOR TAKEOFF on the tablet.

IMPORTANT - Wait for the main rotor RPM to increase and ROTOR RPM warning to clear.

Primary display will then show the following – you’re ready to fly!

• LDG ON = Landing light is on

• A.TRIM RELEASED = AP is not on for takeoff

TIP: Press the ACK soft key to dismiss the messages, so you may see new messages in bright colour.
 High Performance Group – Airbus H135 Quick Start Guide
12. Increase collective (your Throttle control) to take off and go fly!
If you’re new to helicopters then you may find the external view easier to see how the helicopter tilts as you control it.

13. FLIGHT MODES – Control the level of difficulty of your experience

The tablet home page has a tile which lets you select between the three flight modes:

• XBOX = Designed for the Xbox and PS4 controllers. This is the easiest mode.
• BASIC = Default mode, powerful control but torque effects removed.
• ADV = Advanced mode, more real helicopter characteristics including needing to control the antitorque.
High Performance Group – Airbus H135 Quick Start Guide
 High Performance Group – Airbus H135 Quick Start Guide
14. Higher performance mode – “NR HI”
The “NR HI” button to the left of the ENG engine control switches enables a higher performance mode with faster climb
rate and more sensitive collective. Click the button to enable and max vertical speed from a hover increases from
approx. 550ft per minute to 1,100ft per minute.

15. Hotkeys
CONTROL Input H135 Function Default keyboard binding
TOGGLE VARIOMETER FADEC On/Off
TOGGLE WING LIGHTS SPOT LIGHT On/Off
MIXTURE 3 AXIS (0 TO 100%) SPOT LIGHT Up/Down
MIXTURE 4 AXIS (0 TO 100%) SPOT LIGHT Left/Right
AUTOPILOT MASTER Basic Auto pilot including HDG, ALT, NAV modes. Z

Note: VS mode is not supported, even though it

visibly engages.
AUTOMATIC ENGINE START Start engines and engage FADEC Ctrl+E
Control panel view shortcuts CTRL+1, 2, 3, 4

TIP: See the tools\KEY BINDINGS.txt for a complete listing of special hotkeys.

TIP: MSFS generic keyboard shortcuts - https://www.gamesradar.com/uk/microsoft-flight-simulator-2020-keyboard-

controls/

16. Co-Pilot and doors

• Co-pilot show / remove – simply click on the left seat co-pilot / seatbelt
• Doors – click on the front inside handle, or use tablet menu to open / close

17. (OPTIONAL) EFBConnect – display webpages in the cockpit

When switching to the EFB page, you will see a notice to start the EFBConnect app:
 High Performance Group – Airbus H135 Quick Start Guide

You may join our discord for the EFBConnect download (free, but beta): https://discord.com/invite/2atu5xQ
 High Performance Group – Airbus H135 Quick Start Guide
18. Feedback on this guide
Message me on Discord:

• Maintainer: davux3 (Dave)

• Originator: OneSeventyTwo (Neil) (Helpfully created this documented and pushed Dave to update it – we all
thank Neil!)

Document version: 1.3 (H135 v1.3)