MATERIAL SAFETY DATA SHEET

FEVICOL AC DUCT KING LAG COATING E-84

SECTION I - IDENTIFICATION OF COMPANY/ BUSINESS
NAME :PIDILITE INDUSTRIES LIMITED
ADDRESS : Ram Krishna Mandir Road, Kondivita, Andheri (E), Mumbai 400 059.
Telephone : 91-022-2836 7085. E-mail: [email protected]
USE : Water based Acrylic polymer emulsion use for Textile Lagging & Wrapping coating on
A.C.ducts.
SECTION II- IDENTIFICATION OF HAZARDS
TOXIC EFFECTS OF EXPOSURE/ CONTACT :
HMIS Rating: Health – 0, Flammability – 0, Reactivity - 0
SKIN CONTACT : May cause irritation, defatting & dermatitis of skin on prolonged/ repeated contact.
EYE CONTACT : May cause mild irritation, tearing and reddening of eyes.
INHALATION : May cause mild irritation of respiratory track during cutting, grinding, etc.
operations. On prolonged or repeated exposure, may cause nausea, headache
and dizziness.
INGESTION : Not anticipated as normal route of entry.
LONG TERM EFFECTS: May affect lungs, blood, liver and central nervous system. This product
does not contain regulated levels of NTP, IARC, ACGIH or OSHA listed
carcinogens.
SECTION III – HAZARDOUS CONSTITUENTS OF MATERIAL
COMPONENT CAS NUMBER PERCENT
High-boiling hydrocarbon 9072-35-9 1 % Max
Calcium Carbonate 471-34-1 20 % Max
Kaolin Clay 1332-58-7 2 % Max
Titanium Dioxide 13463-67-7 6 % Max
Product does not contain materials listed in the OS&HA Hazard Communication Standard 29 CFR
1910.1200 or the Canadian Workplace Hazardous Materials Information System list.
SECTION IV- FIRST AID MEASURES
SKIN CONTACT: Flush skin with soap & water while removing contaminated clothes. Seek medical
help if required. Wash contaminated clothes before reuse.
EYE CONTACT: Immediately flush eyes with plenty of water for at least 20 minutes. Consult
Physician if irritation persists.
INHALATION : Move the subject to fresh air. If respiration is difficult, seek help from Physician.
INGESTION : Immediately give two glasses of water to drink. Do not induce vomiting. Never
give anything by mouth to an unconscious person. Call a Physician.
NOTE TO PHYSICIAN: There is no specific antidote, treatment should be given symptomatically.
SECTION V - FIRE AND EXPLOSION HAZARD OF MATERIAL
FLAMMABILITY: Non-Flammable. FLASH POINT: NA
EXPLOSIVE LIMITS (% by vol.): LEL: - UEL: - AUTOIGNITION TEMPERATURE : NA
FIRE EXTINGUISHING MEDIA: Use Water spray, foam, Dry Chemical Powder or carbon dioxide to
extinguish the fire.
THERMAL DECOMPOSITION PRODUCT: May yield acrid smoke and irritating gases with oxides of
carbon and chlorine containing gases.
SPECIAL FIRE FIGHTING PROCEDURE: Wear self contained breathing apparatus or equivalent
[MSHA/ NIOSH - approved].
UNUSUAL FIRE AND EXPOLSION HAZARDS: There is possibility of pressure buildup in closed
containers when heated. Cool the containers with water.

INITIALS : PAGE : 1/3

MSDS CODE : 013SD81537 REV. : 0.2 DATE : 28.04.2011

PDF created with pdfFactory Pro trial version www.pdffactory.com

 SECTION VI - ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS: No adverse health effects from clean-up of spilled material. Use
personal protective equipment & handling listed under sections VII & VIII
ENVIRONMENT PRECAUTIONS: Review fire and safety precautions before proceeding with clean
up. Use appropriate personal protective equipment during clean up. Dike and
contain spill with inert material [e.g. sand, earth, saw dust, etc.] and transfer to
containers for final disposal.
CLEANING METHODS: Wash floor with water after cleaning the area with inert material. Clear water
may be sewered for biological treatment.
SECTION VII- HANDLING AND STORAGE
HANDLING PROCEDURE: Protect against physical damage. Observe good hygiene practices. Use
appropriate Personal Protective Equipment [PPE] during handling.
STORAGE REQUIREMENTS : Keep in cool, dry and in a ventilated place. Keep container tightly
closed when not in use. Maintain good housekeeping.
SECTION VIII- EXPOSURE CONTROL/ PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PROTECTIVE EQUIPMENT:
HYGIENE MEASURES: Do not eat, drink or smoke when working. Wash hands before breaks and
after work.
EYE : Use splash proof safety goggles or equivalent while handling this product.
SKIN : Normally not required. Use nitrile gloves, aprons if condition s warrant.
RESPIRATION: None required if good ventilation is maintained in the area. Otherwise suggested to
wear OSHA (29 CFR 1910.134) approved respirator where concentrations is more.
OTHERS : Eye wash facility.
ENGINEERING CONTROLS : Mechanical local exhaust or other engineering controls to minimize
exposure.
COMPONENT ACGIH EXPOSURE LIMITS [TWA] OSHA PERMISIBLE
EXPOSURE LIMITS
Calcium Carbonate Not established 15 mg/m3 TWA (Total dust),
5 mg/m3 TWA (Respirable dust)
3
Kaolin Clay 2 mg/m (Respirable dust), 15 mg/m3 TWA total dust,
particulate matter containing no 5 mg/m3 TWA (Respirable dust)
asbestos and <1% crystalline silica
Titanium Dioxide 10 mg/m3 TWA 15 mg/m3 TWA (Total dust)
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE : White paste.
ODOUR : Mild odour
BOILING POINT (0C) : NA
VISCOSITY @ 300C : 500 – 700 Ps
SPECIFIC GRAVITY (WATER=1) : 1.4 – 1.6
SOLUBILITY IN WATER : Miscible.
VAPOUR PRESSURE AT 25 0C : NA
pH (5% Soln. In Water) : 8.0 – 9.0
SECTION X - STABILITY AND REACTIVITY DATA
CHEMICAL STABILITY : Stable under normal ambient conditions.
INCOMPATIBILITY : Not established.
HAZARDOUS POLYMERISION : Will not occur.
CONDITIONS TO AVIOD : Keep away from freezing and heating.
SECTION XI - TOXICOLOGICAL INFORMATION
No adverse health effects expected if the product is handled in accordance with the Safety Data
Sheet and the Product Label.
INITIALS : PAGE : 2/3

MSDS CODE : 013SD81537 REV. : 0.2 DATE : 28.04.2011

PDF created with pdfFactory Pro trial version www.pdffactory.com

 COMPONENT LD50/ LC50
Calcium carbonates Oral Rat – 6450 mg/kg
Kaolin clay Not established
Titanium dioxide Not established
SECTION XII - ECOLOGICAL INFORMATION
No ecological information available
SECTION XIII - DISPOSAL INFORMATION
This product does not meet the defination of hazardous waste under the U.S. EPA hazardous Waste
Regulations 40 CFR 261. May be disposed off in an approved landfill site. For more restrictive
requirements, disposed off in accordance with current local or central regulation.
SECTION XIV - TRANSPORTATION INFORMATION
The material is not considered as dangerous under Transportation Regulations. The material is not
regulated under DOT or IATA.
SECTION XV - REGULATORY INFORMATION
U.S. EPA TSCA - The material is in compliance with the TSCA Inventory requirements.
CANADIAN CEPA DSL - The material is in compliance with the Canadian Domestic Substance List.
EINECS–This product can not be imported into Europe unless the REACh requirements are met.
AUSTRALIA AICS : This product is in compliance with the Australian Inventory of Chemical
Substance requirements.
KOREAN TCCL : This product is in compliance with the Korean Existing Chemicals List requirements.
This product may contain chemical substances that are regulated for export by various government
agencies (such as the Environmental Protection Agency, the Bureau of Industry and Security, or the
Drug Enforcement Administration, among others.).
EPA SARA Title III Sec. 313 – Unless listed below, this product does not contain toxic chemicals
subject to the reporting requirements of section 313 of Title III of the SARA, 1986 and 40 CFR part 372.
SECTION XVI - MISCELLANEOUS INFORMATION
DISCLAIMER: The data presented here is based on information we believe to be reliable but
unknown risks may be present. We disclaim liability for damage or injury which
results from the use of the above data and nothing contained therein shall constitute
a guarantee or a warranty (including warranty of Merchantibility or fitness for a
particular purpose) or representation (including freedom from Patentability) by us
with respect to the accuracy or completeness of the data, the product described or
their use for any specific purpose as known to us. The final determination of the
suitability of information, the manner of use of information or product and potential
infringement of patents is the sole responsibility of the user.

ISSUED BY SAFETY DEPARTMENT R M RAJE TEL. NO. 2836 7085 EXT. 7277

INITIALS : PAGE : 3/3

MSDS CODE : 013SD81537 REV. : 0.2 DATE : 28.04.2011

PDF created with pdfFactory Pro trial version www.pdffactory.com