EN VEGAWAVE 61 Relay (DPDT)

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Specification sheet

VEGAWAVE 61
Relay (DPDT)
Vibrating level switch for powders
Technical data

Process pressure -1 … +25 bar/-100 … +2500 kPa


(-14.5 … +363 psig)
Process temperature -50 … +250 °C (-58 … +482 °F)
Density > 0.008 g/cm³ (0.0003 lbs/in³)
Ambient temperature on -40 … +80 °C (-40 … +176 °F)
the housing
Storage and transport -40 … +80 °C (-40 … +176 °F)
temperature
Hysteresis approx. 2 mm (0.08 in) with vertical instal-
lation
Process fitting Thread from G1½, 1½ NPT, flanges from
DN 50, 2"
Operating voltage 20 … 253 V AC, 50/60 Hz; 20 … 72 V DC
Power consumption 1 … 8 VA (AC), approximately 1.5 W (DC)

Application area Switching delay When being covered: 0.5 s, when being
uncovered 1 s
The VEGAWAVE 61 is a level switch for universal use in powders and SIL qualification Optionally up to SIL2
fine-grained bulk solids. The VEGAWAVE 61 detects reliably and robust
the min. or max. level. The tuning fork is ideal for use either in adhesive
and abrasive products as well as in bulk solids with very low density. Materials

The wetted parts of the instrument are made of stainless steel 316L.
Your benefit
The supplied process seal is made of Klingersil C-4400.
• Minimum time and cost expenditure thanks to simple setup without You will find a complete overview of the available materials and seals in
medium the "configurator" on our homepage at www.vega.com/configurator.
• Reliable function due to product-independent switching point
• Low maintenance costs thanks to robust design Housing versions

The housings are available in plastic, stainless steel or Aluminium.


Function They are available with protection ratings up to IP 67.

With the VEGAWAVE 61 series, the tuning fork is used as sensor ele- Electronics versions
ment. If the medium covers the tuning fork, the amplitude is damped.
The electronics detects this damping and converts it into a switching The instruments are available in different electronics versions. Apart
command. from the versions with transistor output, contactless electronic switch
and relay output, a two-wire version for connection to a signal condition-
ing instrument and a NAMUR version are also available.

Approvals

The instruments are suitable for use in hazardous areas and are ap-
proved, for example, according to ATEX, FM, CSA and IEC.
You can find detailed information on the existing approvals in the "con-
figurator" on our homepage at www.vega.com/configurator.

VEGA Grieshaber KG, Am Hohenstein 113, 77761 Schiltach/Germany, www.vega.com VEGAWAVE 61 - 34646-EN-151205
Specification sheet

Operation Dimensions

The mode and sensitivity of the level switch can be adjusted on the
electronics module. A signal lamp shows the switching status of the
instrument.

33 mm
(1.30")
5 SW 46 mm

22 mm
(0.87")
(1.81")

G1½ A

178 mm (7.01")
ø 43 mm
(1.69") ø 34 mm
(1.34")

220 mm (8.66")
4

150 mm (5.91")
3

22 mm
(0.87")
Electronics and connection compartment - relay output
1 Potentiometer for switching point adaptation 1
2 DIL switch for mode adjustment
3 Ground terminal
4 Connection terminals
5 Control lamp

Electrical connection 1 Threaded version G1½


2 Threaded version G1½ up to 250 °C

Information

You can find further information on the VEGA product line on our home-
page www.vega.com.
In the download section under www.vega.com/downloads you'll find
free operating instructions, product information, brochures, approval
3 documents, instrument drawings and much, much more.
2 1
Instrument selection

With the "Finder" at www.vega.com/finder and "VEGA Tools" you can


Wiring plan select the most suitable measuring principle for your application.
1 Relay output You can find detailed information on the instrument versions in the
2 Relay output "Configurator" at www.vega.com/configurator and "VEGA Tools".
3 Voltage supply

You can find details on electrical connection in the instrument operating Contact
instructions on our homepage at www.vega.com/downloads. You can find the VEGA agency serving your area on our homepage
www.vega.com.

VEGAWAVE 61 - 34646-EN-151205 VEGA Grieshaber KG, Am Hohenstein 113, 77761 Schiltach/Germany, www.vega.com

You might also like